Loading ...
Loading ...
Loading ...
11
Install Range Hood
1. Using 2 or more people, hang range hood on the 2 mounting
screws through the mounting slots on the back of the hood.
A
B
C
A. Mounting hanger bolts
B. Mounting slots
C. Flat washers and nuts
2. Install the flat washers and nuts to the hanger bolts. Level
the range hood and tighten the nuts.
Connect Vent System
For Vented Installations:
1. Assemble the damper (if needed) to the mounting boss using
(3) 3.5 x 9.5 mm screws.
2. Assemble the vent system to the damper (if used) or the
mounting boss.
A. Metal duct
B. Vent clamps
C. Mounting boss
3. Secure all of the connections with vent clamps.
4. Check that the backdraft damper (if used) works properly.
A
B
C
B
A
B
C
Front of range hood
A
B
C
D
Parallel
For Non-Vented (recirculating) Installations:
1. Mount the air deflector and flexible duct assembly to the air
deflector bracket using (4) 3.5 x 9.5 mm screws supplied
with the Recirculation Kit.
A. Air deflector bracket
B. Air deflector/flexible duct assembly
C. 3.5 x 9.5 mm screws (4)
2. Loosen the 4 nuts on the mounting boss. The back flange of
each nut should be approximately
3
/
16
" (5 mm) from the face
of the mounting boss.
3. Expand the flexible section of vent duct to the top of the
range hood top plate.
4. Check the mounting boss handle for alignment. The
mounting boss handle must align parallel with the front
of the range. If alignment is needed, loosen one of the
vent clamps and adjust as necessary. Retighten any vent
clamps that are loosened.
5. Secure all of the connections with vent clamps.
6. Reach inside the range hood cavity and grasp the handle
of the mounting boss. Pull down to align the nuts through
the cut-out holes in the module top cover. Push back into
the half-slots to assemble. Tighten the 4 nuts using the
1
/
2
" (13 mm) special tool or
1
/
2
" (13 mm) socket and driver
with extension.
A. Inside of range hood cavity
B. Mounting boss handle
C. Half slots in module top cover (4)
D. Nuts (4)
NOTE: For ceiling heights above 9 ft (1.8 m), an appropriate
length of 6" (15.2 cm) ducting (not supplied) will be required.
Loading ...
Loading ...
Loading ...