Loading ...
Loading ...
Loading ...
PREPARING FOR BOBBIN WORK
How to Create Bobbin Work
Appendix A-5
A
1
f
Wipe the bobbin case (gray) with a soft lint
free cloth to clean it.
g
Insert the bobbin case so that the mark
on the bobbin case aligns with the ● mark
on the machine.
* Align the and ● marks.
a mark on the bobbin case
b ● mark on the machine
c Bobbin case
h
Wind a decorative thread around the
bobbin by hand. After winding the bobbin
so it is filled as shown below (about 80%),
cut the thread.
For precautions on winding the bobbin for
embroidering, refer to step
b of “Selecting the
Pattern” on page A-8.
i
Using scissors carefully trim the thread tail
as close to the bobbin as possible.
a Beginning of wound thread
Note
• The bobbin case (gray) cannot be used in
any way other than bobbin work. After
creating bobbin work, refer back to the
steps in “Preparing the Bobbin Thread” on
page A-4 for removing and cleaning the
bobbin case (gray), and then reinstall the
standard bobbin case.
CAUTION
• Be sure to use the bobbin case (gray) when
creating bobbin work. Using any other bobbin
case may result in the thread becoming
tangled or damage to the machine.
• Make sure that the bobbin case is correctly
installed. If the bobbin case is incorrectly
installed, the thread may become tangled or
the machine may be damaged.
a
b
b
a
CAUTION
• Be sure to use the machine’s included bobbin
or one designed specifically for this machine.
Using any other bobbin may result in damage
or injuries.
* Actual size
a This model
b Other models
c 11.5 mm (approx. 7/16 inch)
Note
• Slowly and evenly wind the thread around
the bobbin.
• For best results, wind the bobbin so the
thread is snug and not twisted.
CAUTION
• If thread extends beyond the top of the bobbin
too much, the thread may become tangled or
the needle may break.
Loading ...
Loading ...
Loading ...