Loading ...
Loading ...
Loading ...
14
GB
Troubleshooting
Possible causes / Solution:
• The plug is not plugged into the socket, or not making contact.
• There has been a power failure.
• The fuse has blown. Try to plug another appliance into the socket.
• You are using an extension cord? Try to plug the dryer’s power cord directly into the
socket.
• The door is not closed securely?
• The PROGRAMMES knob has not been set properly (see Start and Programmes).
• The Start/Pause button has not been pressed (see Start and Programmes).
• You have set a delayed time (see Start and Programmes).
• The filter has not been cleaned (see Maintenance).
• The water container needs emptying? The empty water light is flashing? (see
Maintenance).
• The heat pump filter needs cleaning? (see Maintenance).
• The temperature setting is not ideal for the type of fabric you are drying (see Start
and Programmes, and see Laundry).
• The correct drying time has not been selected for the load (see Laundry).
• The air intake grille is obstructed (see Installation, and see Maintenance).
• The items were too wet (see Laundry).
• The dryer was overloaded (see Laundry).
•
The water container was probably not emptied at the start of the programme. Do not
wait for the empty water signal, always check and empty the container before starting
a new drying programme (see Maintenance).
• This is normal, the light flashes when the container is full. If the light is on but not
flashing it is just a reminder to empty the container (see Start and Programmes).
• If the Option lights and the START/PAUSE light flash together with other lights on,
then:
- Turn off and remove the plug. Clean the filter and the condenser (see
Maintenance). Then replace the plug, turn on and start another programme. If
the same combination of lights are on, note down the lights and contact the
Service Centre (see Service).
! For safety the dryer has a maximum programme time of 5 hours. If an automatic
programme has not sensed the required final moisture in this time the dryer will
complete the programme and stop. Check the above points and run the programme
again, if the results are still damp, contact the Service Centre (see Service).
•
The dryer has gone into standby mode to save power. This occurs :
- if you have left the dryer on or have had a power cut
- if you leave the dryer without starting a programme
- after your drying programme has finished
Press and hold the On/Off button and the lights will come on again.
Problem:
The tumble dryer won’t start.
Drying cycle will not begin.
Its taking a long time to dry.
Empty water light is flashing but the
dryer has only been running for a short
period.
Empty water light is on and the water
container is not full.
The OPTION lights and the START/
PAUSE light Flash amber.
Programme finishes and clothes are
damper than expected..
The lights on the dryer control panel
are off although the dryer is switched
on.
One day your dryer seems not to be working. Before you call your Service Centre (see Service), go through the following
troubleshooting suggestions:
Note:
This tumble dryer, in compliance with new energy saving regulations, is fitted with an automatic standby system which is enabled after about 30
minutes if no activity is detected. Press and hold the ON-OFF button until the dryer reactivates.
Loading ...
Loading ...