UCC15NJII OWNER’S MANUAL AND INSTALLATION INSTRUCTIONS

Loading ...

49-1000437 Rev. 0 15

GRAVITY DRAIN (Cont.)

4. Connect a straight 5/8" barbed connector to

the drain hose, securing with the supplied hose

clamp.

5. Cut an 8"piece of 5/8" OD x 7/8" OD tygon

FOHDUSODVWLFWXELQJ6OLGHRQHHQGRIWKHWXEH

RQWRWKHFODPS/HDYHWKHRWKHUHQGRIWKHWXEH

lying on the floor of the base pan until the unit is

positioned over the floor drain.

5RXWHWKHGUDLQWXEHHLWKHUD,QVHUWWKHGUDLQ

tube through the base pan into the floor drain

RUE5RXWHWKHGUDLQWXEHWKURXJKWKHOHIWKROH

in the lower back panel and connect to barbed

elbow and secure with a clamp.

7. Reinstall the upper back panel.

5HLQVWDOOWKHVHUYLFHDFFHVVSDQHO/HYHOWKH

unit. 7KHUHDUH/HJ&DSVLQWKHKDUGZDUHSDFNHW

that can snap onto the leveling legs if they are

going to show when the unit is level.

Water Supply

The recommended water supply tubing is 1/4" OD

FRSSHU6WDLQOHVVVWHHOIOH[RUUHLQIRUFHG3&9WXEH

may also be used. Install an easily accessible shut-

off valve between the supply and the unit. This shut-

off valve should not be installed behind the unit.

The water connection is at the back of the cabinet.

Connect using a compression fitting, one is supplied

tied to the water inlet tube at the back of the cabinet.

When built in: Coil enough tubing behind the

machine so it can be pushed into the cavity without

kinking the tubing.

Drain

Hose

Drain Hose,

Route to

building drain

Barbed

Elbow

Water Inlet

7XEHILHOG

VXSSOLHG

Installation Instructions

INSTALLATION INSTRUCTIONS

PLACEMENT OF THE ICE

MACHINE

The ice machine is supplied with a power cord.

Do not remove the grounding pin from the cord's

SOXJ'RQRWXVHH[WHQVLRQFRUGV)ROORZDOOFRGHV

Connect the machine so its own 115v, 15amp

circuit.

1. If the electrical outlet for the ice maker is behind

the unit, plug it into the unit.

2. Position the unit in the installation opening.

3. Turn on the water supply. Make sure that the

icemaker is plugged in and the power is on.

4. Slide the unit into the installation opening,

paying special attention to water supply and drain

connections. Do not kink!

5. Pour a couple of quarts of water into the ice

VWRUDJHELQRQGUDLQSXPSHTXLSSHGPDFKLQHV

the drain pump should start and water should

pump out. Check for leaks.

6. Replace the service access panel.

/HYHOWKHXQLWDVQHHGHG

Loading ...

OWNER’S MANUAL AND INSTALLATION INSTRUCTIONS - Page 15