Loading ...
Loading ...
Loading ...
• Clean the fan and other surfaces of the range hood regularly using a cloth moistened with mentholated
spirits or non abrasive liquid detergent.
• The active carbon help to filters purify the air that is replaced in the environment. The filters are not washable
or reusable and must be replaced at a maximum every four months. The saturation of the active carbon filter
depends on the frequency of use of the appliance , by the type of cooking and the regularity of the cleaning
of the aluminum filters.
• The lights are designed to be used during cooking – not for prolonged general illumination of the environment.
Prolonged use of the lights will reduce the duration of the bulb.
LIGHT REPLACEMENT - INCANDESCENT.
• Remove the aluminium filters from the range hood.
• Un-screw the globe.
• Replace the globe.
• Re-install the aluminium filters.
Globe: Tubular E14 40Watts 240volts
• LIGHT REPLACEMENT - HALOGEN
12 volt 20 W Halogen.
Remove the glass retaining ring and glass.
Replace the globe with another of the same type.
Replace the glass and retaining ring.
Controls: (Fig.9 B) Symbols are explained below for all models except BWCG90X:
A = LIGHT
B = OFF
C = SPEED I
D = SPEED II
E = SPEED III
G = MOTOR WORKING indicator.
Controls: (Fig.10) only for BWCG90X
Push-button A = on/off lights switch
Push-button B = on/off rangehood switch. The appliance switches on at speed level 1, If the rangehood is
on depress the push-button for 2 sec. to switch off the rangehood . If the cooker hood is at speed level 1 it will
not be necessary to depress the push-button to switch the rangehood off. Decreases the motor speed.
Display C = indicates the motor speed level selected and activates the timer.
Push-button D = switches on the rangehood . Increases the motor speed. Touching the key at 3rd speed,
the intensive function runs for 10', then the appliance go back to work at the original speed. During this
function the display blinks.
Key E = The Timer times the functions on activation for 15 minutes, after which they are switched off. The
Timer is deactivated by re-pressing Key E. When the Timer is activated the decimal point must flash on the
display. The Timer cannot be activated if the intensive speed is functioning.
The “clean air” function is activated by pressing key E for 2 seconds when the appliance is switched off. This
switches the motor on for 10 minutes every hour at the first speed. During functioning a rotary movement of
the peripheral segments must be visualised on the display. When this time has passed the motor switches off
and the fixed letter “C” must be visualised on the display until the motor re-starts after 50 minutes for another
10 minutes and so on. Press any key apart from the light keys to return to normal functioning. Press key E to
deactivate the function.
• Active carbon/grease filter saturation:
- When display item C flashes, at a speed where it alternates with the letter F (e.g. 1 and F), the grease filters
must be washed.
- When display item C flashes, at a speed where it alternates with the letter A (e.g. 1 and A), the carbon
filters must be replaced.
After the clean filter has been positioned correctly, the electronic memory must be reset by pressing button
A for approximately 5 seconds, until the indication F or A shown on the display C stops flashing.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR EVENTUAL DAMAGES CAUSED BY
BREACHING THE ABOVE WARNINGS.
Loading ...
Loading ...
Loading ...