Loading ...
Loading ...
Loading ...
treatment, re-use and recycling of this product, please contact your local authority or domestic waste collection
service.
INSTALLATION INSTRUCTIONS
Electric Connection
The appliance has been manufactured as a class II, therefore no earth cable is necessary.
The connection to the mains is carried out as follows:
BROWN = L line
BLUE = N neutral
If not provided, connect a plug for the electrical load indicated on the description label. Where a plug is
provided, the range hood must be installed in order that the plug is easily accessible.
An omnipolar switch with a minimum opening of 3mm between contacts, in line with the electrical load and
local standards, must be placed between the appliance and the network in the case of direct connection to
the electrical network.
• The minimum distance between the support surfaces of the cooking pots on the cook top and the lowest
part of the range hood must be at least 65 cm. If a connection tube composed of two parts is used, the upper
part must be placed outside the lower part. Do not connect the range hood exhaust to the same conductor
used to circulate hot air or for evacuating fumes from other appliances generated by other than an electrical
source. Before proceeding with the assembly operations, remove the anti-grease filter(s) (Fig.7) so that the
unit is easier to handle.
In the case of assembly of the appliance in the suction version prepare the hole for evacuation of the air.
• We recommend the use of an air exhaust pipe with a diameter of 150. If a pipe with a smaller diameter is
used, the efficiency of the product may be reduced and its operation may become noisier.
• FIXING TO THE WALL
Drill the holes A as per the distances indicated (Fig.2). Fix the appliance to the wall and align it in horizontal
position to the wall units. When the appliance has been adjusted, definitely fix the hood using the screws A
(Fig.5).
For the various installations use screws and screw anchors suited to the type of wall (e.g. reinforced concrete,
plasterboard, etc.). If the screws and screw anchors are provided with the product, check that they are
suitable for the type of wall on which the hood is to be fixed.
• FIXING THE DECORATIVE TELESCOPIC FLUE
Arrange the electrical power supply within the dimensions of the decorative flue. If your appliance is to be
installed in the ducting version or in the version with external motor, prepare the air exhaust opening. Adjust
the width of the support bracket of the upper flue (Fig.3). Then fix it to the ceiling using the screws A (Fig.3)
in such a way that it is in line with your hood and respecting the distance from the ceiling indicated in Fig.2.
Connect the flange C to the air exhaust hole using a connection pipe (Fig.5). Insert the upper flue into the
lower flue. Fix the lower flue to the hood using the screws B provided (Fig.5), extract the upper flue up to the
bracket and fix it with the screws B (Fig.3).
If your appliance has the lower connections indicated as in Fig. 4 A, the fixing to be carried out is that shown
in Fig. 6.
• RECIRCULATING FILTERING VERSION
Install the hood and the two flues as described for installation of the hood in ducting version. To assemble the
filtering flue refer to the instructions contained in the kit provided. Charcoal filters can be fitted in the ducting
unit located inside the hood (Fig.8). Filter can be purchased as an accessory, part number ACK62260.
Additional Installation Notes.
Rangehoods may be ducted in two ways:
1. Ducted to the atmosphere (outside).
2. Recirculating.
We recommend ducting to the atmosphere to ensure optimum performance. Recirculating the air back into
the room should only be used when outside extraction is not possible. To ensure maximum performance
when ducting it is important the ducting that carries the fumes away, be as short and as straight as possible.
Loading ...
Loading ...
Loading ...