Loading ...
Loading ...
Loading ...
22 23
Minimum Clearances
When the upright cooker is installed abutting a side or rear wall, the wall must be
of non-combustible material, eg ceramic tiles. The following minimum clearances
to combustible materials must be observed:
• Minimumclearancefromhotplatetosidewallmustbe200mm.
• Minimumclearancefromhotplatetorearwallmustbe200mm.
INSTALLATION INSTRUCTIONS
These instructions are for the use of a qualified installer only
Statutory regulations
This appliance is to be installed in accor
dance with the manufacturer’s installation
instructions, local gas fitting regulations, applicable building codes, electrical wiring
regulations, and according to the installation code for Gas Appliances AS5601/AG6O1.
Consult SAA wiring rules as appropriate.
Safety Warnings About Installation
• Thecookermustbeinstalledandservicedbyaqualiedtechnician.
• Acerticateofcompliancemustbesuppliedbytheinstallerandkept
by the customer.
• Allpackagingmaterialsincludingprotectiveplasticlmmustberemoved
before the cooker is installed.
• Thepipesusedininstallationmusthavesufcientloopstoallowforthe
cooker to be moved for service.
• Thesafetychainmustbetted.
• Thecookermustnotbeliftedorpulledusingtheovenhandle
• Thecookermustbeservicedandcheckedevery3to4yearsdepending
on usage or condition.
7. Grill Element/Top Element - All models: This element must never be sprayed with
any detergents. A damp cloth and a bottlebrush can be used to clean the roof of the
oven and the element itself. Never soak the element and always dry it after cleaning as
not doing so can lead to deterioration. It is important to clean this area regularly as fats
spit up and stick to the ceiling and element while grilling and they may burn, smoke and
give out unpleasant odours.
WARNING: please follow these safety precautions during cleaning.
Avoid the ignitors becoming wet, as this is an electrical part and moisture can cause it to
malfunction.
Avoid water spilling into hob burner holes when burners have been removed.
Always dry unit before use, never let water and detergents sit in and on unit.
CARE OF CATALYTIC LINERS
Some models have catalytic liners installed within the oven cavity. They are the matte
finished light coloured panels on the sides and the matte finished panel at the rear of the
oven.
They work by collecting the grease and oil residues that occur during cooking. The
liner self cleans by absorbing fats and oils and burning them to ash which is then easily
removed from the floor of the oven with a damp cloth.
The liner may discolour with age and should a large amount of fat be spilled onto the
liner it may affect its efficiency. To overcome this problem set the oven to maximum
temperature for about 10 - 20 minutes. Catalytic liners are designed for a working life
of about 300 hours.
When the oven is cool wipe out the floor of the oven.
Manual cleaning of the catalytic liners is not recommended. Damage will occur if
soap impregnated steel wool pad or any other abrasives are used. We also do not
recommend the use of aerosol cleaners on the liners.
If the walls of a catalytic liner are no longer effective you can remove the surplus grease
with a soft cloth or sponge soaked in hot water then go through the cleaning cycle as
described above. The lining must be porous to be effective. Catalytic liners are designed
for a working life of about 300 hours.
KITCHEN CABINETRY WARNING
NOTE: ALL ADJACENT SURFACES TO THE COOKER MUST BE ABLE TO
WITHSTAND NORMAL HEAT TRANSFER FROM THE COOKER AND THE HEAT
RELEASED FROM THE OVEN DOOR WHEN OPENED. GLEMGAS ACCEPTS NO
RESPONSIBILITY FOR CABINET DAMAGE FOR DAMAGE TO KITCHEN
CUPBOARDS AND DRAWERS DUE TO INCORRECT INSTALLATION. IF IN DOUBT
INSTALL A HEAT SHIELD.
VINYL WRAPPED CUPBOARD FINISHES ARE NOT A SUITABLE SURFACE.
CALL GLEM GAS ON 1 300 307 917 FOR ADVICE.
Loading ...
Loading ...
Loading ...