Loading ...
Loading ...
Loading ...
9
INSTALLATION INSTRUCTIONS
OPERATING INSTRUCTIONS
INSTALLATION INSTRUCTIONS
DISCONNECTING THE LIQUID PROPANE CYLINDER
• Turn the grill burner valves “OFF” and make sure the grill is cool.
• Turn the Liquid Propane cylinder valve “OFF” by turning clockwise until it stops.
• Detach the regulator assembly from the cylinder valve by turning the quick coupling nut counterclockwise.
• Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install the type of dust cap
on the cylinder valve outlet that is provided with the cylinder valve. Other types of caps or plugs may result
in leakage of propane.
LEAK TESTING – GENERAL
Although gas connections on the grill are leak tested prior to shipment, a complete leak test must be per-
formed at the installation site. Before each use, check all gas connections for leaks using the procedures
listed below.
If the smell of gas is detected at any time, you should immediately check the entire system for leaks.
BEFORE TESTING
Make sure all packing materials have been removed from the grill, including the burner tie-down straps.
LIGHTING THE GRILL
1. Place the legs in up position.
2. Make sure the propane cylinder is tightly threaded into the regulator
(hand tighten only).
3. Open lid. Always open lid when lighting.
4. Push and turn Main burner knob slowly to IGNITE/HI as show in
Fig.4, burner should light immediately.
5. If ignition does not occur in 3-5 seconds, turn the control knob
“OFF”. Wait 5 minutes before attempting to re-light the grill. If the
grill fails to ignite after the second attempt, call customer service at
336-379-7900 for assistance. With burner lit, gently close the lid and
allow the grill to warm up for 5 minuets prior to use.
Note: If the knob can’t spark insert the
match into the lighting rod as show
in Fig.5. Ignite the match and insert
though the cooking grids to the burner.
TURNING THE GRILL OFF
1. Turn knob to “OFF” position.
2. Turn the propane cylinder control knob to the “OFF” position.
Caution: Do not attempt to re-light the grill without following all
the lighting instructions.
3. Allow the grill body to cool at least 30 minutes before attempting
to move or transport.
4. Remove and clean grease tray prior to transporting, then reinstall.
Make a solution of one part liquid detergent and one part water. You will need a spray bottle, brush, or rag to
apply the solution to the ttings. For the initial leak test, make sure the Liquid Propane cylinder is full.
TO TEST
1. Turn the burner valves off.
2. Turn the Liquid Propane cylinder valve counterclockwise to open the valve.
3. Apply the soap solution to all gas ttings. Soap bubbles will appear where a leak is present.
4. If a leak is present, immediately turn the gas supply “OFF” and tighten leaky ttings.
5. Turn the gas back “ON” and recheck.
6. Should the gas continue to leak from any of the ttings, turn the gas supply “OFF” and contact customer
service at 866-994-6390 or email [email protected]
7. If there is evidence of excessive abrasion or wear, or the hose is cut, it must be replaced prior to the outdoor
cooking gas appliance being put into operation.
Only those parts recommended by the manufacturer should be used on the grill. Substitutions will void the
warranty.
INSTALLER FINAL CHECK
Maintain specied clearance of 36 inches from combustible materials and construction.
• All internal packaging has been removed.
• The hose and regulator are properly connected to the Liquid Propane cylinder.
• The unit has been tested and is free of leaks.
• The gas supply shutoff valve has been located.
• All burners are installed.
• Keep the instruction manual for future reference
m WARNING
Check all gas supply ttings for leaks before each use. Do not use the grill until all connections have been
checked and do not leak. Do not smoke while leak testing. Never leak test with an open ame.
m WARNING
1. The grill and its individual shutoff valve must be disconnected from the gas supply piping system during
any pressure testing of that system at test pressure in excess of 1/2-in.PSI (3.5kpa).
2. The outdoor cooking gas appliance must be isolated from the gas supply piping system by closing its
individual manual shutoff valve during any pressure testing of the gas supply piping system at test
pressure equal to or less than 1/2-in.PSI (3.5kpa).
m WARNING
1. Do not store spare Liquid Propane cylinders under or near this appliance.
2. Never ll the cylinder beyond 80 percent capacity.
3. If the information in item 1&2 is not followed exactly, a re causing death or serious injury may occur.
m WARNING
Do not store grill indoors unless the cylinder is disconnected. Do not store cylinder in a building, garage, or
any other enclosed area, and keep area, and keep out of reach of children at all times.
8
1
3
2
OFF
MainBurners
IGNITE / HI
LO
OFF
IGNITE / HI
LO
IGNITE / HI
LO
OFF
Figure 4
Figure 5
1. Push
2. Turn knob to Ignite/Hi
3. Adjust ame
Loading ...
Loading ...
Loading ...