Loading ...
Loading ...
Loading ...
8
1. The pureWash should be fastened to the wall, just above and behind your washing machine. It is
recommended that one of the mounting holes on the pureWash be mounted to a wall stud, if possible.
One set of mounting screws are included. If it is not possible to mount the pureWash to a wall stud,
you should use “molly” type expandable screw anchors, available at your local hardware store. For
any other type of mounting scenarios (concrete block, etc.) please consult your local hardware store
for assistance.
2. Place your Mounting Bracket onto the wall with the tabs facing up and away from the wall, making
sure it is level, mark the locations of the screw holes. If necessary, pre-drill your holes and use the
supplied Wall Anchors. Fasten the Mounting Bracket to wall using the supplied screws.
3. Place your pureWash against the wall and gently slide the unit down into the lock position of the
mounting bracket slots.
4. Connect the cold water hose from your washer to the “To Washing Machine” port on your pureWash.
Check that the rubber washer in the hose is in place and properly tighten the hose, but DO NOT
overtighten. Use a wrench to hold the hose bib secure while tightening the hose connection.
5. With the supplied hose, connect the “Cold Water In” port on the pureWash to your Cold Water
Supply Faucet. Make sure rubber washers are in place and properly tighten, but DO NOT
overtighten. Again, use a wrench to hold the hose bib secure on the pureWash while tightening.
Do not use ood-preventing hoses with auto shutoff devices. The devices can be tripped during ll
and prevent the machine from lling properly.
Be sure the cold water connection has a shut-off valve and that hose connections are tight. CLOSE
the shut-off valve at the end of each wash.
6. Plug the power adapter into the DC adapter plug-in on the right side of your pureWash and then plug
the adapter into a wall outlet.
7. Ensure all hoses are properly installed and tightened, and that the power supply has been properly
installed. SLOWLY turn the water supply back on and check for any leaks or drips. Gently tighten ttings
if leaks are apparent, but DO NOT overtighten.
INSTALLATION
CAUTION: The hot water hose should not be disconnected from the washer. You can turn off the hot water or
leave it on, but the hose must be installed to the washing machine to prevent backflow of water out of the
washing machine during use.
Water supply faucets should be readily accessible to permit turning them off when pureWash Pro is not
being used.
IMPORTANT: Turn off water supply whenever pureWash Pro is not in use.
Loading ...
Loading ...
Loading ...