Loading ...
Loading ...
Loading ...
A
Changing from natural gas to
liquid gas
1. Fully tighten the bypass screw.
2. Put the knob back.
3. Connect the appliance to the electricity.
Changing from liquid gas to
natural gas
1. Unscrew approximately one turn the
bypass screw position A.
2. Put the knob for the oven functions
back.
3. Connect the appliance to the electricity.
WARNING!
Put the mains plug into the mains
socket only if all parts are back into
their initial position. There is a risk
of injury.
4. Light the burner.
Refer to "Oven - Daily use" chapter.
5. Turn the knob for the oven functions on
the minimum position.
6. Remove the knob for the oven functions
again.
7. Screw on slowly the bypass screw till
the flame becomes minimum and
stable.
8. Put the knob for the oven functions
back.
9. Set the maximum gas flow position on
the knob for the oven functions and let
the oven heat for at least 10 minutes.
10. Quickly turn the knob for the oven
functions from maximum to the
minimum gas flow position.
Control the flame. Make sure the flame
does not go out when you turn the knob to
the minimum gas flow position. There must
be a small regular flame on the oven burner
crown. If the flame goes out adjust the oven
burner again.
Gas grill injector replacement
1. Release the screws which keep the grill
burner in position A.
A
2. Release the burner injector with a 7 mm
socket spanner and replace it with a
right one.
3. Assemble the burner in a reverse
sequence. Before you fix the screw,
make sure that the burner is pushed
correctly to the back panel.
Test the grill injectors.
35
INSTALLATION
Loading ...
Loading ...
Loading ...