Loading ...
Loading ...
Loading ...
10 – ENGLISH
wake. Each alarm’s wake time will be shown in the display. Press the respective Alarm
button again to cancel the alarm. Please also see “How to Change Alarm Settings
and Set the Alarm Via the Main Menu” for additional very important Alarm settings.
Guide to Features (Rear Panel)
1
3
5
4
2
1.
12VDC/1500mA: Use this input to operate the Albergo+ using its included external
power supply. Use only the power supply provided with this product. Should the
power supply become damaged or misplaced, use only a like replacement. Any DC
adapter used must meet the requirements of EN/IEC 60065 and be rated at 12VDC
1500mA and 230V 50Hz (depending on your region’s power requirements). Use of any
DC adapter not recommended by the manufacturer/not meeting this specification may
cause a safety hazard. The connector is 5.5 mm/2.1 mm center positive. It is normal for
the power supply to become warm during use.
2. EXTERNAL ANTENNA: An external telescoping antenna is affixed to this input and
is not intended to be detached. Adjust for best reception. For more, see the section
marked “Digital Radio/FM Reception”.
3. HEADPHONE OUT: Connect a headset (not included) to this variable stereo output for
private listening. The headset will mute the primary speaker. The headset’s volume is
adjusted using the control wheel or the remote control. The remote’s “Mono” button also
affects this output. This stereo output accepts a 3.5 mm stereo male mini connector.
Avoid using headphones at high volume levels to prevent possible hearing damage.
4. AUX IN: To hear audio from another device, such as Tivoli Audio’s Model CD, a MP3
player, or TV, connect said device’s audio output to this stereo input and change the
source to Auxiliary. This stereo input accepts a 3.5 mm stereo male mini connector.
Note: you may need to adjust the volume level differently for an auxiliary device
than the level used for radio listening.
5.
Speaker: Connect the male RCA cable from the optional Tivoli Audio Albergo
Speaker to this female RCA output. Make sure the Stereo/Mono setting is set to
Stereo by pressing the Mono button on the remote control and be sure the display
doesn't show “M” for mono.
Loading ...
Loading ...
Loading ...