Loading ...
Loading ...
Loading ...
Frequently asked questions
98
Problem Possible cause and solution
Fault 406-408 Water inlet fault.
One of these numbers will appear in the display if the flow
pressure is too low and the program will be cancelled.
The flow pressure at the water intake point is too low
(see "Technical data"). Contact Miele Service for advice.
Fault 412-414 Water inlet fault.
One of these numbers will appear in the display if the flow
pressure is too high and the program will be cancelled.
The flow pressure at the water intake point is too high
(see "Technical data"). Contact Miele Service for advice.
Fault 492, 504, 541 Fault during program start. There may still be water in the
wash cabinet.
Clean the filter combination (see "Cleaning and care").
Clean the non-return valve (see "Frequently asked
questions").
Fault 550 The Waterproof system was activated.
Close the water supply valve.
Contact Miele Service.
Fault578 The peak-load cut-out has lasted longer than 3hours.
Have your electrical system and your energy
management system tested by a suitably qualified
person.
Check drainage The water outlet is restricted. There might be water in the
wash cabinet.
Clean the filter combination (see "Cleaning and care").
Clean the drain pump (see "Frequently asked
questions").
Clean the non-return valve (see "Frequently asked
questions").
Remove any kink or loop in the drain hose.
Fault XXX
(XXX stands for a number)
A malfunction may have occurred.
After waiting 10seconds:
Turn the dishwasher back on.
Select the desired program.
Press the Start/Stop button.
If the fault message is displayed again, there has been a
malfunction.
Contact Miele Service.
Loading ...
Loading ...
Loading ...