Loading ...
Loading ...
Loading ...
The appliance must be installed by a suitably qualified
person in accordance with these instructions and with the
requirements of the Australian Wiring Rules AS/NZS 3000.
Fixed wired installations are to be provided with suitable
isolation means in accordance with the said rules.
Any plug socket installed for the purpose of connecting the
appliance to supply must be readily accessible when the
appliance is installed.
Before making the connection, make sure that:
1) the safety circuit-breaker and the electrical system are
able to withstand the load of the appliance
(see nameplate).
2) the power supply system has an earth connection in good
working order in accordance with the regulations in force;
IMPORTANT
The wires in the mains lead are coloured in accordance with
the following code:
GREEN & YELLOW.....................................................EARTH
BLUE ..................................................................... NEUTRAL
BROWN ......................................................................... LIVE
Electric power 1,5 mm
2
core cable (15 amp. Fuse required)
Should conform to local authority requirements.
Also refer to rangehood manufacturers recommendations.
This appliance is supplied with a plug & cord, simply plug
into a 3 pin household socket outlet witch is properly
earthed.
If he supply cord is damaged, it must be replaced by an
authorised service agent.
WARNING: THIS APPLIANCE MUST BE EARTHED.
The flexible mains lead and plug must not be in contact with
hot surfaces.
The correct adjustment is obtained when the flame has a
length of about 3 or 4 mm.
For butane/propane gas, the adjusting screw must be
screwed in thigt.
Make sure that the flame does not go out turning quickly
from the max. flow to the minimum flow .
Refit the knob again.
Adjustments, conversions and gas installations must only be
carried out by an authorised person.
After there placement of the injectors, replace also the label of
the type of gas.
SPECIAL NOTE
After installation or any servicing operation, always ensure that
the appliance is gas sound and that the components are now
operating correctly. Items removed during servicing should be
replaced in the reverse order to their removal.
In order to change the work-top injectors, it is necessary to act
as follows:
- remove the grids
- remove burners
and flame-spreaders.
MINIMUM FLOW ADJUSTMENT FOR HOB-TOP TAPS
In order to adjust the minimum flame setting proceed as
follows: switch the burner on, and set the knob at the
minimum position . Remove the knob from the tap.
The minimum adjusting screw «Z» is on the body of the gas
tap (fig. 2).
5
ELECTRICAL CONNECTION
TAB. 1
Jet mm ø
G
as
Type
kPa
U-LPG 2.75
Natural
1.00 1.20
Burners
Semi-quick
Power MJ/h
7.1
0.90
Auxiliary
4.0
1.50
Quick
11.0
1.63
Triple Crown
12.7
0.73
Semi-quick
7.0
0.53
Auxiliary
3.7
0.95
Quick
11.7
1.00
Triple Crown
12.7
Regulator
NG Regulator
LP Test point
adaptor
- change the injector (see Fig. D) and replace it with another
one suitable for the new type of gas (see tab. 1)
Unscrew the adjusting screw in order to increase the flow
or screw it to decrease the flow.
Fig. D
Fig. 2
2nd SECTION FOR THE USER
WARNING:
Children should be kept away while the oven or grill is in use
since accessible parts become hot.
- Do not use oven base panel as a shelf, make use of the
oven shelves.
- To avoid splattering and smoke, position collecting tray
under the grill with some water in it.
- WARNING -
During use, the appliance becomes hot.
Care should be taken to avoid touching heating elements
inside the oven.
Loading ...
Loading ...
Loading ...