Loading ...
Loading ...
Loading ...
14
Disassembly of the worktop must only be done by a
qualified service technician.
DISASSEMBLE OF WORK-TOP
In case it is necessary to repair or replace the inside compo-
nents, act as follows:
Remove the grids, remove burners and flame-spreaders (see
fig. 6), unscrew the visible screws “V” placed on the work-top
(see fig. 7). Disassemble the work-top by unscrewing the rear
screws “A” (see fig. 8 according to the models). In this way it
is possible to lift the work-top and to reach the inside compo-
nents.
OPTIONAL: ONLY FOR THE MODELS EQUIPPED WITH
TELESCOPIC RAILS
The oven is equipped with telescopic rails to position the pan
and wire grid (Fig. 3d).
You can change the position, depending on your personal
taste and needs ofdifferent foods (Fig. 3e).
Fig. 6
Fig. 7
V
mod. 296
Fig. 8
A
GREASING OF TAPS
If a tap becomes hard to be turned, grease it using a specific
grease withstanding high temperatures. Act as follows: open
the work-top and disassemble also the control panel as
described on the previous paragraph. Unscrew the two fixing
screws from the burner body (see picture) and remove the
cone.
TAPS REPLACEMENT
Act as follows: open the work-top and disassemble also the
control panel as described on the previous paragraph.
Unscrew screw nut D of the gas tube supplying the burner.
Unscrew screw V fixing the tap to the bridle and remove it (see
picture).
Note: Every time the tap is replaced, it is necessary to replace
the seal gasket too check the connection seal by means of
soapy water.
Clean the cone and its slot by means of a cloth soaked with
solvent. Slightly grease the cone with the relevant grease, put
it in its slot, and turn it some times. Remove the cone again,
remove the excess grease making sure the gas entries are not
obstructed by grease residue. Assemble everything carefully
in the opposite direction check the connection seal by means
of soapy water.
15
7
D
V
Fig. 3D
Fig. 3E
Loading ...
Loading ...