Loading ...
Loading ...
Loading ...
Mains hair clipper instructions
11
CLEANING YOUR NASAL TRIMMER
Periodically after use, turn the trimmer off and rinse the cutting head under warm,
running water. For more thorough cleaning, remove the attached cutting head by turning
it slightly counter clockwise. Then rinse the entire head under running water. After clean-
ing, replace desired head by turning it slightly clockwise and wipe the entire trimmer dry
with a soft cloth. Always replace the protective cap after use.
CLEANING AND MAINTENANCE
Your Wahl Clipper and Trimmer Blades were oiled and aligned before leaving our
factory; however it is possible for the blades to get bumped out of alignment. Blades
must be re-aligned if they have been removed for cleaning or replacement. To determine
if realignment is necessary, compare your clipper blades with this sketch.
1. End of top blade teeth should be .025” to .050” (064mm to 1.27mm) back from bottom
blade. This is important so that the clipper does not cut too close or allow the moving
cutter to touch the skin.
2. Extreme left hand tooth of top blade must be covering or to the left of the rst small
tooth of the bottom blade.
3. Extreme right hand tooth of top blade must be touching the big tooth on the bottom
blade.
If blade alignment is incorrect, add a few drops of oil to the blades, turn clipper on for a
few moments, turn off and unplug. Loosen screws slightly and adjust. Tighten screws
after blade is aligned.
Loading ...
Loading ...
Loading ...