Loading ...
Loading ...
Loading ...
6
INSTALLATION INSTRUCTIONS
Prepare Built-In Oven
1. Decide on the final location for the oven. Avoid drilling or
cutting into house wiring during installation.
2. To avoid floor damage, set the oven onto cardboard prior to
installation. Do not use handle or any portion of the front
frame for lifting.
3. Remove the shipping materials and tape from the oven.
Remember to keep the corner posts and other materials that
may be needed for installation. Remember to remove bottom
vent and bottom vent trim from foam packing on top of oven
4. Remove the hardware package from inside the bag
containing literature.
5. Remove and set aside racks and other parts from inside the
oven.
6. Verify foam strip is attached to the back of the control panel
as shown in the following picture below. If the foam strip is
not present, please reference the “Assistance or Service”
section of the Use and Care Guide or contact the dealer from
whom you purchased your built-in oven to order Part Number
W10489273.
NOTE: Once the oven is installed in the cabinet, make sure
the foam strip is positioned against the cabinet face.
7. Move oven and cardboard close to the oven’s final location.
Remove Oven Door(s)
IMPORTANT: Use two hands to remove oven door. For double
ovens, repeat the process for each door.
1. Prior to removing the oven door, prepare a surface where you
will place it. This surface should be flat and covered with a
soft blanket, or use the corner posts from your packaging
material.
2. Open the oven door.
3. Locate the oven door hinge locks in both corners of the oven
door, and rotate the hinge locks toward the oven door to the
unlocked position. If the door hinge lock is not rotated fully
(see illustration B), the door will not remove properly.
4. Partially close the door to engage the door latch locks. The
door will stop at this point.
5. Using two hands, grasp the edges of the oven door. Lift and
pull the oven door toward you and remove. You may need to
gently shift door from side to side as you pull.
6. Set the oven door(s) aside on the prepared covered work
surface, with the oven door resting on its handle.
7. To continue with the oven installation, go to the “Positioning
Oven Feet for Multiple Cabinet Cutout Heights” section.
A. Foam strip
WARNING
Excessive Weight Hazard
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
A
A. Oven door hinge lock in
locked position
B. Oven door hinge lock in
unlocked position
A
B
Loading ...
Loading ...
Loading ...