Loading ...
Loading ...
Loading ...
8
ENGLISH
Tools you will need
• Phillips head + driver (manual or motorized) /
Ø 8 mm (0.3 inches) Drill bit / Level / Stud nder / Drill
How to attach to masonry walls
Please follow the below direction.
1 Use a drill bit Ø 8 mm (0.3 inches) to drill a hole for the anchor
location within a depth of 80 mm (3.1 inches) to 100 mm
(3.9 inches).
2 Clean the drilled hole.
3 Insert the sealed wall mounting anchor to the hole. (When
inserting the anchor, use a hammer.)
Wall mounting
anchor
4 Set the wall mount on the wall by aligning to the location of
the hole. And, set the angle adjusting part to face upward.
5 Align the wall mounting screw to the hole and tighten it.
Then, fasten the screws at torque of 45 kgf/cm (39.06 lbf/in)
to 60 kgf/cm (52.08 lbf/in).
Wall mounting screw
• When mounting a TV on the wall, make sure not to
install the TV by hanging the power and signal cables
on the back of the TV.
• Do not install this product on a wall if it could be
exposed to oil or oil mist. This may damage the
product and cause it to fall.
• Make sure that children do not climb on or hang on
the TV.
• Use a platform or cabinet that is strong and large
enough to support the TV securely.
• When installing the product, rst check that the wall is
strong enough. Use the anchors and screws provided.
- If you use anchors and screws that are not specied
by the manufacturer, they may not hold the weight
of the product, causing safety issues.
• Be sure to use the accessory cable provided.
Otherwise, friction between the product and the wall
may cause damage to the connector.
• When drilling holes into the wall, make sure you use
a drill and drill bit with the specied diameter. Ensure
that you also follow the instructions regarding the
depth of the holes.
- Otherwise, the product may be installed incorrectly
and cause safety issues.
• Wear safety gloves when installing the product. Do
not use your bare hands.
- Otherwise, it may cause personal injury.
• If some parts of the wall mount do not touch the wall
after it is attached, in addition to the other mounting
hardware, add the double sided tape included with
the accessories to stick the mount to the wall.
• If some parts of the wall mount do not touch the wall
after using the wall mounting screws for wood, use
the remaining screws.
• Be sure to use only the exclusive wall mounting screws
provided as accessories.
• If you want to connect the TV Cable that is connected
to the back panel partition, please use the enclosed
Punching Guide.
Loading ...
Loading ...
Loading ...