Loading ...
Loading ...
Loading ...
Clip
Connector
Water line
Water line
The water lines must be connected
with the potable water only.
Note:
To operate properly, the ice maker
requires a water pressure of 207~689
Kpa.
Connect filter outlet line to the fridge
The outlet line of the water filter
should be connected with the inlet line
of the refrigerator by a Two-Way
Connector.
The water lines must be fully inserted
into the center of the connector to
prevent water leaking.
Insert the 2 clips in the install pack as
shown in the diagram, and then
confirm that each clip holds the line
firmly.
Connecting the filter inlet line to
the water supplier
Screw the adaptor onto a suitable 3/4”
BSP connector water outlet, and use
the spanner to tighten it. Fully insert
the water line into the check valve.
Then insert the clip in the install pack
as the figure shown below.
The initial dark discoloration of
water is normal.
After installed the filter, please open
the water valve to flush the filter for 5
minutes before use.
Third,
position as the figure shown below,
and confirm that each clip holds the
water line firmly.
insert the 2 clips in the proper
Clip
Water line
Water line
FLOW
Water line
Water Filter
Water line
Outlet
Inlet
Second, fully insert the water lines
into the Inlet and Outlet of the water
filter.
10
Clip
Connector
Filter inlet line
Water valve
Spanner
Check valve
FLOW
Water
The connector and the check valve is
provided as one part. You should use
the new connector incidentally but not
the old one you have.
Loading ...
Loading ...
Loading ...