Loading ...
Loading ...
Loading ...
8
Installation
This appliance is supplied with a set of adjustable feet and a
glass cover. The glass cover is prefitted.
Fitting the adjustable feet
1. Remove all parts that are not permanently fixed, especially
the pan supports and burners.
2. Remove any accessories from the oven.
3. Lift one side of the appliance off the floor and tilt it slightly.
4. Screw the adjustable feet into the mounting holes on the
underside of the appliance.
Note: If the appliance needs to be moved again, screw the
adjustable feet in fully.
5. Only finally level the appliance once the electricity and gas
have been connected and all of the installation work is
complete.
Positioning and levelling
Positioning the appliance
When installing the appliance, make sure that there is enough
space in the final installation location to pull the appliance
forwards for cleaning and maintenance work.
The ground underneath must be hard and firm. The wall
immediately behind the appliance must be made from non-
flammable material, e.g. tiles.
If you need to move the appliance in order to position it, make
sure that the adjustable feet are fully screwed in.
Aligning the appliance
Turn the adjustable feet to align the appliance.
Note: Do not align the appliance until all other work has been
completed.
The adjustable feet can be used to elevate the appliance by a
maximum of 50 mm.
Check the alignment of the appliance once it has been installed
in the intended place.
Adjacent units
Any adjacent units must not be made of flammable materials.
The fronts of any adjacent units must be heat-resistant up to at
least 90 °C. If the appliance is installed very close to any other
units, the minimum clearances given in the figure must be
maintained.
Wall fixing
To prevent the cooker from tipping over, you must fix it to the
wall using the enclosed bracket. Please observe the installation
instructions for fixing the oven to the wall.
PLQ
PLQ
PLQ
PLQ
PLQ
Loading ...
Loading ...
Loading ...