FGUS2645LF User Manual

Loading ...

CHANGING THE FILTER

Ordering Replacement Filters

Toorderyourreplacementlters,pleasevisitouronline

store at www.frigidaire.com/store, by calling toll-free

at 877-808-4195, or by visiting the dealer where you

purchased your refrigerator. Frigidaire recommends that you

orderextralterswhenyourstinstallyourrefrigerator,and

thatyoureplaceyourltersatleastonceeverysixmonths.

Water Filter

Thewaterlterislocatedatthetoprightsideofthefresh

food compartment.

Replacing the Water Filter

Ingeneral,youshouldchangethewaterltereverysix

months to ensure the highest possible water quality. Water

Filter Status on the user interface prompts you to replace

thelterafterastandardamountofwater(200gallons/757

liters for PureSource 3

)

hasowedthroughthesystem.

If your refrigerator has not been used for a period of time

(duringmovingforexample),changethelterbefore

reinstalling the refrigerator.

Do not use with water that is microbiologically unsafe or of

unknown quality without adequate disinfection before or after

thesystem.Systemscertiedforcystreductionmaybeused

ondisinfectedwatersthatmaycontainlterablecysts.

Test & certication results:

 • RatedCapacity-200gallons/757litersfor

PureSource 3

iceandwaterlter

 • Ratedserviceow-.50gallonsperminute

 • OperatingTemp.:Min.33°F,Max.100°F

 • MaximumRatedPressure-100poundspersquareinch

 • RecommendedMinimumOperatingPressure:30

pounds per square inch

To replace your PureSource 3

water lter:

It is not necessary to turn the water supply off to change

thelter.Bereadytowipeupanysmallamountsofwater

releasedduringthelterreplacement.

1 Turn Off the ice maker.

2 Removethelterbypushingontheend/faceofthe

lter.

3 Slidetheoldwaterltercartridgestraightoutofthe

housing and discard it.

4 Unpackagethenewltercartridge.Usingthe

alignmentguide,slideitgentlyintothelterhousing

until it stops against the snap-in connector at the

back of the housing.

5 Push rmly until the cartridge snaps into

place (you should hear a click as the cartridge

engages the snap-in connector).

6 Press a drinking glass against the water dispenser

whilecheckingforanyleaksatthelterhousing.

Any spurts and sputters that occur as the system

purges air out of the dispenser system are normal.

7 Afterllingoneglassofwater,continueushingthe

system for about four minutes.

8 Turn On the ice maker.

9 Press and hold the Water Filter button on the Ice

& Water Dispenser control panel for three seconds.

When the display changes from Red to Green, the

status has been reset.

The PureSource 3

iceandwaterlter

systemistestedandcertiedtoNSF/ANSI

Standards 42 and 53 for the reduction of claims

speciedontheperformancedatasheet.

More about your Advanced Water Filter

Air Filter (some models)

Theairlterislocatedatthetopofthefreshfood

compartmentnexttothewaterlter.

Replacing the Air Filter

Ingeneral,youshouldchangetheairltereverysix

months(thelterstatuslightonthecontrolpanelprompts

youtoreplacethelteraftersixmonths)toensureoptimal

lteringofrefrigeratorodors.Youmaywanttoadjustthis

time period depending on the types and amounts of food

you typically store in your refrigerator. To replace you

PureSource Ultra

airlter:

1 Pulltheairlterhousingstraightout.

2 Removetheoldlteranddiscardit.

3 Unpackthenewlterandplaceitinsidethehousing.

4 Slide the housing back into position.

Here is the product number to request when ordering:

PureSource 3

Water Filter

Part #WF3CB

PureSource Ultra

Air Filter

Part #PAULTRA

Loading ...

User Manual - Page 15