DWB098E50/01 User Manual

Loading ...

Operation

These instructions apply to several appliance variants. It is

possible that individual features are described which do not

apply to your appliance.

Note: Switch on the extractor hood when you start cooking and

switch it off again several minutes after you have finished

cooking. This is the most effective way of removing the kitchen

fumes.

Control panel model 1

Control panel

Setting the fan

Switching on the appliance

■ Press the % button.

The fan starts at setting

ƒ.

■ Press the + or - button to change the fan strength.

Switching off

Press the

% button.

Intensive setting

You can use the intensive setting if there is a large build-up of

odours and fumes/vapours.

Press the + button when the fan is at setting

„.

The intensive boost setting

‚ is activated. Pressing the + button

again activates the intensive boost

ƒsetting.

After approx. six minutes, the electronics automatically reduce

the fan to a lower setting . If you want to end the intensive

setting before the preset time expires, press the - button until

the required fan setting is reached.

Fan run-on time

Press the - button until ‚r appears.

After approx. ten minutes, the fan switches off automatically.

Lighting

The lighting can be switched on and off independently of the fan.

Press the B button.

Setting the brightness

Press and hold the

B button until the desired brightness is

reached.

Saturation display

When the metal mesh grease filters or the activated carbon

filter are saturated, a signal sounds for approx. 4 seconds after

the fan is switched off.

In addition, the corresponding symbol appears in the display:

■ Metal mesh grease filter: #

■ Activated carbon filter: ’#

If you have not yet done so, the metal mesh grease filters

should be cleaned or the activated carbon filter changed now.

For instructions on how to clean the metal mesh grease filters,

please refer to the section Cleaning and maintenance.

While the saturation displays are flashing, they can be reset. To

do this, press the – button.

Switching over the display for circulating-air mode

For circulating-air mode, the electronic control display must be

switched over accordingly:

■ The extractor hood must be connected and switched off.

■ Press the % and buttons at the same time until the

™# display for starter sets for circulating-air mode or

’# display for CleanAir circulating air modules

lights up.

■ Repeatedly press the button combination to switch the

electronic control display back to exhaust air mode (

display).

Audible signal

Switching on the acoustic signal

When the fan is switched off, press the

% and + buttons at the

same time for approx. three seconds. An acknowledgement

signal sounds.

Switching off the acoustic signal

Repeat the "Switching on the acoustic signal" process.

Control panel model 2

Control panel

Setting the fan

Switching on the appliance

■ Press the % button.

The fan starts at setting

ƒ.

■ Press the + or - button to change the fan strength.

Switching off

Press the

% button.

Explanation

Fan on/off

- Reduce the fan settings/fan run-on time

+ Increase the fan settings/intensive setting 1, 2

Light on/off/dimming

ERRVW