Loading ...
Loading ...
Loading ...
10
E. Position the brackets so they’re as at as possible on the pipe
Loosen one bracket slightly on the servo and slide it so that the bracket is as level
as possible on the pipe. Then tighten the bracket on the servo and repeat with the
other bracket.
Once you’ve tightened both brackets, make sure that the servo motor is still
centered over the shut-off valve and the valve handle is still at against the servo
lever.
Step 3 (continued)
D. Make sure the shut-off valve handle is at against the servo lever
If the handle for your shut-off valve is already at against the servo lever, you can
proceed to the next step.
If the handle is at an angle or raised off of the servo lever, you can adjust the
height of the servo from the valve as shown here. Use the Allen wrench provided
to loosen the screw on the servo height adjustment. Then adjust the height so that
the shut-off valve handle is at on the servo lever. Then tighten the screw again.
(Make sure the servo motor is still positioned over the center of the shut-off valve!)
Servo
lever
Valve handle
Loading ...
Loading ...
Loading ...