Loading ...
Loading ...
Loading ...
Troubleshooting _27
ERROR IMAGE MEANING SOLUTION
Your Washer has tried to fill but was
unsuccessful.
Make sure the water faucets are open all
the way. Check for kinked hoses.
Check the inlet screens on the fill hoses.
if you use a Flood Safety Device, then
please remove the device and connect
the water hoses directly to the unit.
Problem with control. Call for service.
A fault is detected in the water level
sensor.
Call for service
Jammed Key. Call for service
• Motor speed sensor problem.
• High current detected.
• Motor not running properly.
Restart the cycle pressing the Start/
Pause Button. If the code reappears,
call for service.
Temperature sensor problem. Restart the cycle.
If the code reappears, call for service.
High/Low voltage detected. Restart the cycle.
If the code reappears, call for service.
SilverCare™ control problem Restart the cycle.
If the code reappears, call for service.
Test Mode
Test Mode
Test Mode
System error. Call for service.
Too many suds are detected during the
washing session.
The unit is put on hold until the suds
are reduced. Then, the unit will go back
to the operation.
When it finishes washing, End and
SUdS codes will blink in turn.
To prevent it, cut down on detergents.
For any codes not listed above, call 1–800–726–7864 (1–800–SAMSUNG)
05 Troubleshooting
WF448AAW-02535A-10_EN.indd Sec7:27WF448AAW-02535A-10_EN.indd Sec7:27 2011-01-13 ¿ÀÀü 10:19:072011-01-13 ¿ÀÀü 10:19:07
Loading ...
Loading ...
Loading ...