Documents: Go to download!
- User Manual - (English)
- Installation
- Description
- Useful modes
- Control panel
- Care and cleaning
- Before you call for service
- Specification
Table of contents
USER MANUAL
Installation
1. Keep adequate ventilation space around the refrigerator.
- The figure shows the minimum required space for installing the refrigerator. The amount of space around the refrigerator affects the amount of power consumption.
- Insufficient spacing will decrease cooling efficiency and increase energy consumption. This may reduce the life of the unit and void warranty.
- If using the refrigerator in the smaller space dimension than figured, it may cause temperature rise in the unit, loud noise and failure.
- The space between the rear of the refrigerator and the wall should be 60mm or more, and less than 75mm.
If the space is wider than 75mm, you may get injured by touching the compressor and its peripheral parts which are extremely hot during the operation.
Overall space required in use
2. Use the two front adjustable feet to place the refrigerator flatly and firmly on the floor.
3. When right and left doors are not properly aligned, adjust using the adjustable feet.
4. Remove the 4 screws of the lower part of the cabinet and use these screws to set the foot cover. (The foot cover is packed inside the refrigerator compartment.)
5. Connect the power plug to a 230/240 volt. 10 amp. power point.
Description
1. Door pocket (3 pcs)
2. Refrigerator shelf (2 pcs)
3. Shelf
4. Bottle pocket (left)
5. Fruit and vegetable crisper
The cover of the fruit and vegetable crisper opens as the case is pulled.
6. Freezer case (small) (3 pcs)
7. Freezer case (large) (2 pcs)
8. Caster (4 pcs)
The casters allow the refrigerator to move back and forth.
9. Adjustable foot (2 pcs)
10. Foot cover
11. Hybrid cooling panel
The panel cools the refrigerator compartment indirectly from the rear. In this way, food is cooled gently without being exposed to cold air flow.
12. Light
13. Utility pocket
SJ-XE676F : 2 pcs
SJ-XE624F : 1 pc
14. Egg holder
15. Bottle pocket (right)
To store large-size bottles, move the partition all the way back.
16. Fresh case (upper)
17. Fresh case (lower)
18. Ice cube maker (2 pcs)
- Do not overfill this tray with water. Otherwise the ice cubes will join together when frozen.
- When ice cubes are made, turn the lever clockwise to put the ice into the ice cube box.
19. Ice cube box (2 pcs)
Note
To prevent the ice cube box from being damaged, do not pour oil into the box or make ice in it.
20. Magnetic door seal (4 pcs)
21. Control panel
Deodorising unit
Deodorising catalyst is installed on the routes of cold air.
There is no need to operate and clean.
If you wish to store large items within your freezer
Useful modes
Extra cool | Express freezing | Express cool | |
Feature |
This mode is to cool Note : Food with high- |
This mode speeds up the time to freeze food. |
This mode is to cool beverages or foods quickly. |
Point of use | Fresh case | Freezer compartment |
Freezer compartment Caution : Do not place glass bottles. There is a high risk that they may burst. |
Operating time | 6 hours *1 | 2 hours *1 | 30 minutes |
|
This mode ends automatically. The alarm sounds. To stop the alarm *2 Press enter button. |
||
After the operation completed |
There is no need for taking beverages or foods out. |
Be sure to take the beverages and foods out when the alarm sounds. If the beverages and foods are left in the freezer compartment over approximately 30 minutes, they may freeze. |
|
At the time of power failure See other models: SJXE676FSL SJFJ676VWH SJFJ676VBK R995DW R995DST during the operation |
This mode is automatically cancelled. | This mode is automatically restarted from the previous state at the time of re-power. |
Control panel
Note
When you press one of the buttons, all icons flash once and show the standby display. If the refrigerator stops because of power failure, the modes except for Extra Cool and Express Freezing function the same way as before at the time of re-power.
Operation is invalid while the refrigerator door is open.
Mode icons or indicators in operation light up on the standby display.
When Express cool is in operation, the icon flashes on the standby display.
When there is no operation for approximately 1 minute, the display returns to the standby display automatically. The standby display turns off if there is no operation for another 1 minute.
Operations of useful modes
Operation of additional modes
Controlling temperature
The refrigerator controls its temperature automatically. However, you can adjust the temperature as below.
How to check the current temperature setting
Press button to select icon.
Setting of Refrigerator / Freezer compartment
Freezer compartment
Adjustable between -13°C and -21°C in steps of 1°C
Refrigerator compartment
Adjustable between 0°C and 6°C in steps of 1°C
Default setting
Basic operations
Advanced Setting of Refrigerator/Freezer compartment
The temperature of the refrigerator compartment and freezer compartment can be adjusted in steps of 0.5 °C by following the steps a to c below.
a. After the step 1 of “Basic operations”, press for 3 seconds or more.
The current preset temperature returns to the “Default setting” (The display is indicated as the picture on the right.)
b. Press and set the temperature.
c. Complete the setting. (Same as step 3 of “Basic operations”.)
Follow the steps a to c again if you want to adjust the temperature in steps of 1°C.
Care and cleaning
Cleaning
- Remove the accessories (e.g. shelves) from the cabinet and the door. Wash them with warm soapy dishwashing water. After that, rinse them in clean water and dry. (Only fruit and vegetable shelf is not removable.)
- Clean the inside with a cloth soaked in warm soapy dishwashing water. Then, use cold water to wipe off soapy water thoroughly.
- Wipe the exterior with a soft cloth each time it gets dirty.
- Clean the Magnetic door seal with a toothbrush and warm soapy dishwashing water.
- Wipe the control panel with a dry cloth.
Before transporting
Wipe up water in the evaporating pan. Before wiping up the water, wait more than 1 hour after pulling out the power plug because the refrigeration cycle equipment is extremely hot. (The evaporating pan is located on the rear of the product.)
Switching off your refrigerator
If the refrigerator needs to be switched off for an extended period, the following steps should be taken to reduce the growth of mould:
- Remove all food.
- Remove the power plug from the power point.
- Clean and dry the interior thoroughly.
- Ensure that all the doors are wedged open slightly for air circulation.
Defrosting
Defrosting is automatically operated by a unique energy saving system.
When the compartment light is blown
Contact the service agent approved by SHARP to replace the light. The light is not to be replaced other than by a qualified service personnel.
Before you call for service
Before calling for service, check the following points.
Problem | Solution |
The outside of the cabinet is hot when touching. | It is normal. The hot pipe is in the cabinet in order to prevent dew generation. |
When there is refrigerator noise. |
It is normal for the refrigerator to make the following sounds.
|
Frost or dew appears inside or outside the refrigerator. |
This may occur in one of the following cases. Use a wet cloth for wiping frost and a dry cloth for wiping dew.
|
The foods in the refrigerator compartment freeze. |
|
Odours in the compartment. |
|
If door alarm does not stop. |
|