Loading ...
Loading ...
Loading ...
CAUTION
! Never shorten any wires, the protection circuit
may malfunction.
! Never wire the speaker negative cable directly-
to ground.
! Never band together multiple speakerās nega-
tive cables.
! If the system remote control wire of the ampli-
fier is connected to the power terminal via the
ignition switch (12V DC), the amplifier will re-
main on with the ignition whether the car
stereo is on or off, which may exhaust battery
if the engine is at rest or idling.
! Install and route the separately sold battery
wire as far as possible from the speaker wires.
Install and route the separately sold battery
wire, ground wire, speaker wires and the am-
plifier as far away as possible from the anten-
na, antenna cable and tuner.
About bridged mode
! Do not install or use this amplifier by wiring
speakers rated at 2 W (or lower) in parallel to
achieve a 1 W (or lower) bridged mode (Dia-
gram B).
Amplifier damage, smoke, and overheating
could result from improper bridging. The am-
plifier surface could also become hot to the
touch and minor burns could result.
To properly install or use a bridged mode and
achieve a 2 W load, wire two 4 W speakers in
parallel with Left + and Right * (Diagram A)
or use a single 2W speaker.
In addition, refer to the speaker instruction
manual for information on the correct connec-
tion procedure.
! For any further enquiries, contact your local
authorized Pioneer dealer or customer
service.
About suitable
specification of speaker
Ensure speakers conform to the following
standards, otherwise there is a risk of fire,
smoke or damage. Speaker impedance is 2 W
to 8 W,or4W to 8 W for two-channel and other
bridge connections.
Subwoofer
Speaker channel Power
Four-channel output
Nominal input:
Min. 100 W
Two-channel output
Nominal input:
Min. 300 W
Three-channel
output
Speaker output
A
Nominal input:
Min. 100 W
Speaker output
B
Nominal input:
Min. 300 W
Other than subwoofer
Speaker channel Power
Four-channel output
Max. input:
Min. 200 W
Two-channel output
Max. input:
Min. 600 W
Three-channel
output
Speaker output
A
Max. input:
Min. 200 W
Speaker output
B
Max. input:
Min. 600 W
En
8
Section
03
Connecting the units
ī
ī
15090308201-Bī<8>
Loading ...
Loading ...
Loading ...