Loading ...
Loading ...
Loading ...
EN11
CLEANING
WARNING
• Do not use steam cleaners.
• Before cleaning, make sure the cooking zones are switched off and that the residual heat indicator (“H”)
is not displayed.
If the iXelium™ logo appears on the glass, the hob has been treated with iXelium™ technology, an exclusive Whirlpool nish which ensures perfect cleaning
results, as well as keeping the surface of the hob shiny for longer.
To clean iXelium™ hobs, follow these recommendations:
• Use a soft cloth (microbre is best) dampened with water or with everyday glass cleaning detergent.
• For best results, leave a wet cloth on the glass hob surface for a few minutes.
IMPORTANT: Do not use abrasive sponges or scouring pads. Their use could eventually ruin the glass.
• After each use, clean the hob (when it is cool) to remove any deposits and stains due to food residuals.
• Sugar or foods with a high sugar content damage the hob and must be immediately removed.
• Salt, sugar and sand could scratch the glass surface.
• Use a soft cloth, absorbent kitchen paper or a specic hob cleaner (follow the Manufacturer’s instructions).
• Liquid spillages on the cooking zones may make pans vibrate or move.
TROUBLESHOOTING GUIDE
• Read and follow the instructions given in the section “Instructions for use”.
• Check that the electricity supply has not been shut off.
• Dry the hob thoroughly after cleaning it.
• If, when the hob is switched on, alphanumeric codes appear on the display, consult the following table for instructions.
• If the hob cannot be switched off after using it, disconnect it from the power supply.
ERROR CODE DESCRIPTION POSSIBLE CAUSES ERROR ELIMINATION
C81, C82
The control panel switches off
because of excessively high
temperatures.
The internal temperature of
electronic parts is too high.
Wait for the hob to cool down before
using it again.
C83
The control panel indicates the error
code hob off because of an issue on
electronic circuit.
Cooktop has been supplied with
over voltage.
Cooktop may be still used but call
the After-Sales Service.
C85
Hob is not able to give power to the
pot.
Pot is not suitable to the induction
hob.
Use another induction pot.
F02 or F04 or C84
The connection voltage is wrong or
issue to the power supply.
The sensor detects a discrepancy
between the appliance voltage and
that of the mains supply.
Disconnect the hob from the mains
and check the electrical connection.
F01, F05, F06, F07, F10, F12, F25,
F33, F34, F36, F37, F46, F47, F48,
F49, F58, F61, F62, F63, F72, F74,
F77
Disconnect the hob from the power supply. Wait a few seconds and plug it again.
If the problem persists, call the After-Sales Service and specify the error code.
NOISES MADE BY THE HOB
The induction cooktops can generate a set of noise and vibration during normal operation, depending on the type of material and the processing of the food,
such as those described below:
• Noise contact: this type of vibration is due to the use of pots made of different materials superimposed.
• Sounds click at mid-lower power: this noise is produced in order to achieve the low-mid power required.
• Sounds like rhythmic click: this noise is produced when operating several areas of cooking and / or high performance.
• Hissing weak: this noise is due to the type of container used and the quantity of food contained.
• Background noise: the induction cooker is equipped with a fan aimed at cooling the electronic components and for this reason during operation and also
for a few minutes after switching off the hob you hear the noise of the fan. Increase / decrease the cooking zones activated, the background noise of the
fan may increase or decrease.
These conditions are normal and essential for the proper functioning of the induction system, they are not indication of failure or damage.
Loading ...