Loading ...
Loading ...
Loading ...
15
Installation Instructions
INSTALLING THE WASHER
1. Run some water from the hot and cold faucets to flush
the water lines and remove particles that might clog up
the water valve screens.
2. Remove the inlet hoses and rubber washers from the
plastic bag and install the rubber washers in each end
of the inlet hoses.
3. (90° elbow end)
Carefully connect the inlet
hose marked HOT to the
outside “H” outlet of the
water valve. Tighten by
hand, then tighten another
2/3 turn with pliers.
Carefully connect the other
inlet hose to the inside “C”
outlet of the water valve. Tighten by hand; then tighten
another 2/3 turn with pliers. Do not crossthread or
over-tighten these connections.
4. Connect the inlet hose ends to the HOT and COLD
water faucets tightly by hand, then tighten another 2/3
turn with pliers. Turn the water on and check for leaks.
5. Carefully move the washer to its final location. Gently
lift up on the front of the washer and slide back.
NOTE: Do not use the dispenser drawer or door to lift
the washer.
6. With the washer in its
final position, place a
level on top of the
washer (if the washer
is installed under a
counter, the washer
should not be able to
rock). Adjust the front
leveling legs up or
down to ensure the washer is resting solid. Turn the
lock nuts on each leg up towards the base of the
washer and snug with a wrench.
NOTE: Keep the leg extension at a minimum to
prevent excessive vibration. The farther out the
legs are extended, the more the washer will vibrate.
If the floor is not level or is damaged, you may have
to extend the rear leveling legs. For undercounter
installations, you can adjust the rear legs by removing
the front service panel.
Loading ...
Loading ...
Loading ...