Loading ...
Loading ...
Loading ...
14 15
The machine does not start to seal after vacuuming:
1. There is a vacuum pressure sensor in this appliance. The appliance will not begin to
seal automatically if the vacuum pressure inside the bag is not able to reach to the
predetermined vacuum pressure. Check the sealing strip and the foam gaskets for debris
and correct positioning. Wipe clean and smooth them back into place, and try again.
2. Check the sealing strip and the foam gaskets for debris and positioning. Make sure there
is no breakage or distortion on both foam seal gaskets. Wipe clean and secure them
back into place.
3. The vacuum bag may have a leak. To test for a leak, seal the bag with some air in it,
submerge in water, and apply pressure. Bubbles indicate a leak. If there is a leak,
re-seal or use another bag.
4. There may be leaks along the seal caused by wrinkles, debris crumbs, grease or liquids.
Open the bag, wipe along the sealing area on the inside of the bag and smooth it out
along the sealing strip before re-sealing.
Air has entered into the bag after being sealed:
1. There may be leaks along the seal caused by wrinkles, debris crumbs, grease or liquids.
Open the bag, wipe along the sealing area on the inside of the bag and smooth it out
along the sealing strip before re-sealing.
1. The release of natural gases or fermentation from foods (such as fresh fruits and
vegetables) may occur. If you think food has begun to spoil, open the bag and discard
food. Lack of refrigeration or uctuating temperatures in the refrigerator can cause food
to spoil. If food is not spoiled consume food immediately.
2. Check the bag for a puncture or hole which may have released the vacuum seal. Do not
vacuum seal hard items with sharp points (like bones or shards of nut shell). If necessary,
cushion sharp edges in the contents of the bag with paper towels.
The bag melts:
1. Should the sealing strip or sealing element overheat and melt the bag, it may be neces-
sary to lift the lid and allow sealing strip and element to cool for a few minutes.
The canister will not vacuum:
1. Make sure the hose adaptor is rmly connected both to the appliance and the canister.
2. Check if the knob of the canister to ensure it is set to the Seal position.
3. Check if there is any damage or cracks in the canister or lid, if yes, change it for a
new one.
4. Check the function of the vacuum sealer.
5. Make sure the rim of the canister is clean. If all the above situations are excluded, please
contact customer service.
RHVS1_IB_FA_221112.indd 15 22/11/12 10:08 AM
Loading ...
Loading ...
Loading ...