Loading ...
Loading ...
Loading ...
8 49-80612-3
Care and Cleaning
Stainless Steel Hood
Light bulbs
NOTE: The glass cover should be removed
only when cool.
CAUTION
Before replacing the bulb, disconnect electrical
power to the hood at the main fuse or circuit
breaker or main power disconnect switch
located on the control housing. Allow bulbs to
cool before touching.
For safety, do not touch a hot bulb with bare
hands or a damp cloth.
To change the light bulbs:
1. Remove the lamp lens cover by inserting a
small flat-blade screwdriver into each of the
three slots and gently prying it free.
NOTE: Do not remove the outer trim ring
(lamp assembly).
2. Grasp the bulb and pull it straight out.
3. Using gloves or a dry cloth, remove the new
bulb from the packaging. (Wearing latex
gloves may offer a better grip.) The bulb
must be the same wattage, 120-volt, 25-watt
halogen with a G-9 base. Early-life bulb
failure may occur if wattage is too high.
4. Push the bulb straight all the way into the
receptacle.
5. Replace the lens cover by inserting the
three retaining tabs into the slots and
pressing into place.
NOTE: For improved lighting, clean the glass
cover frequently using a damp cloth. This should
be done when the hood is completely cool.
6. Reconnect electrical power to the hood.
NOTE: Order replacement 120-volt, 25-watt
halogen bulb with G-9 base, WB25X10020.
These bulbs can be ordered from your
Monogram supplier.
NOTE: Make sure the tabs are inserted into
the slots.
ONLY use a new 120-volt, 25-watt halogen
bulb with a G-9 base.
NOTE: Do not touch the new halogen bulb
with bare fingers. Skin oils can cause early-life
bulb failure.
On some models, the lights are located on
the sides, on the underside of the hood.
On some models, the lights are located on the
front and back, on the underside of the hood.
Receptacle
Use gloves
or cloths
Outer trim ring
(lamp assembly)
Do not remove
Bulb
Removable inner
lamp lens cover
Tab
Use a small flat-blade screwdriver
to remove the lamp lens cover.
Loading ...
Loading ...
Loading ...