Loading ...
Loading ...
Loading ...
Do not install the washer where it is directly exposed to sunlight, wind, rain etc.
Plug the power cord of this washer into a properly installed standard power point that is switched & earthed.
Your machine requires a floor drainage slope (or hole) that will SAFELY DISPOSE of the FULL
FLOW of any water that may leak out should the machine malfunction.
It is therefore the OWNER'S RESPONSIBILITY to make sure this machine is installed in an area with
a drain hole (or slope) that will prevent any possibility of water damage to floor coverings or property.
Permissible water temperature : Max 70°C(160°F)
Permissible water pressure : Max 80psi (550kpa, 8kg/cm
2
), Min 4psi (30kpa, 0.3kg/cm
2
)
If water temperature & pressure is greater than above, it may cause damage to the machine. If you
have uncontrolled water temperature & pressure you should fit a temperature & pressure relief valve
to ensure that water temperature & water pressure remains within the safe limits. Consult a plumber
or electrician if you are unable to adjust water temperature and pressure.
Do not over tighten the coupling nuts with a tool. Inlets are plastic : Do not strip or crossthread.
Rev. : 02 (04T15)
Loading ...
Loading ...
Loading ...