Loading ...
Loading ...
Loading ...
FR-CA
5
EN
1. Important Safety Instructions
This device complies with Part 15 of the FCC Rules / Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
To satisfy FCC / IC RF exposure requirements, a separation distance of 20 cm or more should be
maintained between the antenna of this device and persons during device operation.
To ensure compliance, operations at closer than this distance is not recommended.
To disable Wi-Fi module on DEEBOT, power the robot ON. Place the robot on the Charging Dock
making sure the Charging Contacts on DEEBOT and the Charging Dock Pins make a connection.
Press and hold the AUTO Mode Button on the robot for 20 seconds until DEEBOT emits 3 beeps.
To enable Wi-Fi module on DEEBOT, power the robot OFF and then power ON. The Wi-Fi module is
turned on when DEEBOT is restarted.
39. Do not modify or attempt to repair the appliance or the battery pack (as
applicable) except as indicated in the instructions for use and care.
40. Disconnect the battery pack from the appliance before making
any adjustments, changing accessories, or storing appliance.
Such preventive safety measures reduce the risk of starting the
appliance accidentally.
41. Place the cords from other appliances out of the area to be
cleaned.
42. Do not operate the vacuum in a room that has lit candles on
furniture that the vacuum may accidentally hit or bump into.
43. Do not allow children to sit on the vacuum.
44. Recharge only with the charger specied by the manufacturer. A
charger that is suitable for one type of battery pack may create a
risk of re when used with another battery pack.
45. Use appliances only with specifically designated battery packs.
Use of any other battery packs may create a risk of injury and re.
46. Do not handle plug or appliance with wet hands.
Loading ...
Loading ...
Loading ...