Loading ...
Loading ...
Loading ...
(124,1)
北米Model "A1747BE-B" EDITED: 2019/ 12/ 19
Security indicator light
6. Carry the access key fob and touch the
door lock sensor.
All doors will lock, an electronic chirp will
sound once, the hazard warning flashers
will flash once, and the security indicator
light will start flashing rapidly.
After rapid flashing for 30 seconds (stand-
by time), the security indicator light will
then flash slowly (twice approximately
every 2 seconds), indicating that the
system has been armed for surveillance.
! Disarming the system
S02AS0205
Perform either of the following procedures.
. Briefly press the disarm button (for less
than 2 seconds) on the access key fob/
remote transmitter.
. Carry the access key fob and grip the
front door handle (models with “keyless
access with push-button start system”).
The flashing of the security indicator light
will then change slowly (once approxi-
mately every 3 seconds from twice ap-
proximately every 2 seconds), indicating
that the alarm system has been disarmed.
! Emergency disarming
S02AS020501
If you cannot disarm the system using the
access key fob/transmitter (i.e. the trans-
mitter is lost, broken or the transmitter
battery is too weak), you can disarm the
system without using the access key fob/
remote transmitter.
You can disarm the system if you turn the
ignition switch from the “LOCK”/“OFF” to
the “ON” position with a registered key/
access key fob.
NOTE
For models with “keyless access with
push-button start system”, if the bat-
tery of the access key fob is dis-
charged, perform the procedure de-
scribed in “Switching power status”
F9-27. In such a case, replace the
battery immediately. Refer to “Repla-
cing battery of access key fob” F11-51.
! Valet mode
S02AS0206
When you choose the valet mode, the
alarm system does not operate. In valet
mode, the access key fob/transmitter is
used only for locking and unlocking the
doors and for panic activation.
To enter the valet mode, change the
setting of your vehicle’s alarm system for
deactivation mode. Refer to “Activating
and deactivating the alarm system” F2-
24. The security indicator light will continue
to flash once every 3 seconds indicating
that the system is in the valet mode.
To exit valet mode, change the setting of
your vehicle’s alarm system for activation
mode. Refer to “Activating and deactivat-
ing the alarm system” F2-24.
Keys and doors/Anti-theft system
2-28
Loading ...
Loading ...
Loading ...