Loading ...
Loading ...
Loading ...
49-3000087 29
Troubleshooting Tips... Before you call for service
TROUBLESHOOTING TIPS
Problem Possible Causes What To Do
Time
Remaining
jumped to a
lower number
The estimated time may
change when a smaller load
than usual is drying
This is normal.
Cannot make a
selection and
the dryer beeps
twice
The dryness Level, Temp or
option that you are trying to
select is incompatible with
the chosen dry cycle
This is normal.
Dryer is
running but 00
is displayed
in Time
Remaining
The Ext Tumble option was
chosen
This is normal. During extended tumbling, the time remaining is
not displayed. The extended tumbling option lasts approximately
60 minutes.
Clean Lint Filter
(message)
Power button was activated Press Start/Pause to begin a dry cycle and the message will
disappear.
Dryer doesn’t
heat
Fuse is blown/circuit breaker
is tripped; the dryer may
tumble but not heat
Check the building’s fuse/circuit breaker box and replace both
fuses or reset both breakers. Your dryer may tumble if only one
fuse is blown or one breaker tripped.
Inconsistent
drying times
Type of load and drying
conditions
The load size, types of fabric, wetness of clothes and the condition
of the lint filter and/or air intake vent located on the front of the
dryer will affect drying times.
Type of load and drying
conditions
The load size, types of fabric, wetness of clothes and the length
and condition of the exhaust system will affect drying times.
Glow at the rear
of the drum
Heaters behind the drum This is normal. Under certain drying conditions and room ambient
lighting, the glow of the heaters may be visible at the rear of the
drum.
Clothes are still
wet and dryer
shut off after a
short time
The door was opened
mid-cycle. The load was then
removed from the dryer and
a new load put in without
selecting a new cycle
A dry cycle must be reselected each time a new load is put in.
Small load When drying 3 items or less, choose Quick Dry or Time Dry.
Load was already dry except
for collars and waistbands
Choose Quick Dry or Time Dry to dry damp collars and
waistbands. In the future, when drying a load with collars and
waistbands, choose More Dry.
Dryer is not level Move dryer to an even floor space or adjust leveling legs as
necessary until even.
Clothes are
wrinkled
Overdrying Select a shorter drying time.
Remove items while they still hold a slight amount of moisture.
Select a Less Dry or Damp setting.
Letting items sit in dryer after
cycle ends
Remove items when cycle ends and fold or hang immediately, or
use the Ext Tumble option.
Overloading Separate large loads into smaller ones.
Loading ...
Loading ...
Loading ...