Loading ...
Loading ...
Loading ...
11
6.5 Wash Mode - Lowers the SpinScrub™ brushes
to make contact with the floor for scrubbing action.
6.6 Dry Mode - Raises the SpinScrub™ brushes
off of the floor and also stops the spinning of
the brushes.
6.7 Scrub Mode - (FH40170 Series only) Lowers the
SpinScrub™ brushes to the floor and stops the
suction for extra cleaning with solution and water.
Switch to dry mode to pick up any remaining
dirty water.
6.8 To release solution, squeeze trigger (A)
6.9 Slowly move cleaner forward and backward over
area to be cleaned. Squeeze trigger to release
solution as needed.
6.10 Overlap strokes by one inch to help prevent
streaking. The cleaner’s suction will pick up the dirty
water throughout cleaning.
6.11 To remove those tough stains, apply extra
cleaning solution by squeezing the trigger (B) as you
normally would and also pressing the Clean Boost™
trigger (C) at the same time.
To greatly enhance drying of the floor surface,
release trigger. Continue to move cleaner over the
area to pick up the dirty solution.
Switch to dry mode to pick up any remaining
dirty water.
To continue cleaning another area, repeat steps 6.8
through 6.10.
NOTE: When cleaning sealed wood floors, make
sure all areas are completely dry. Ensure that no
water remains on the floor.
Empty dirty water tank when the motor sound
becomes higher in pitch and there is a loss of
suction.
6.5 6.6
6.8
6.7
6.9
A
6.11
C
B
CAUTION
! !
Do not use the cleaner to pick up flammable or
combustible liquids or chemicals.
PICKING UP SPILLS
Your cleaner may also be used to pick up small
liquid spills one and a half quarts or less in Dry
Mode, never to exceed 1/4 inch in depth on non-
carpeted floors. Release the trigger and continue to
move cleaner over the area to pick up the spill.
Water will drip from the brushes and underside of the product after use and may puddle. To avoid
damage to wood and laminate flooring and to avoid potential slip hazard, after use A) do not leave the
product on wood and laminate surfaces and remove to a hard surface and B) place unit on absorbent
material (such as a towel) to soak up drips.
CAUTION
! !
Loading ...
Loading ...
Loading ...