Loading ...
Loading ...
Loading ...
13
INSTALLING THE WATER LINE
(CONT.)
1
Installation Instructions
Place the compression nut and ferrule (sleeve)
onto the end of the tubing as shown.
Insert the end of the tubing into the water valve
connection as far as possible. While holding the
tubing, tighten the fitting.
Fasten the tubing into the clamp provided to hold
it in a vertical position. You may need to pry open
the clamp.
Remove the plastic flexible cap from the water valve.
NOTES:
• Before making the connection to the refrigerator,
be sure the refrigerator power cord is not
plugged into the wall outlet.
• We recommend installing a water filter if your
water supply has sand or particles that could clog
the screen of the refrigerator’s water valve. Install
it in the water line near the refrigerator.
Remove the access cover.
CONNECT THE TUBING TO THE
REFRIGERATOR
1
Reattach the access cover.
Typical Compression
Nut
Tubing
Tubing Clamp
Refrigerator Connection
Ferrule (sleeve)
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the
wall. Push the refrigerator back to the wall.
TURN THE WATER ON AND PLUG
IN THE REFRIGERATOR
2
Set the icemaker power switch to the I (on) position.
The icemaker will not begin to operate until it
reaches its operating temperature of -9°C or below.
It will then begin operation automatically if the
icemaker power switch is in the I (on) position.
NOTE: In lower water pressure conditions, the
water valve may turn on up to 3 times to deliver
enough water to the icemaker.
START THE ICEMAKER
3
Power
switch
Loading ...
Loading ...
Loading ...