Loading ...
Loading ...
Loading ...
5
combustible materials, such as furniture, pil-
lows, bedding, papers, clothes, and curtains
at least 3 feet (0,9 m) from the front and top
of the heater and keep them away from the
sides and rear.
- Do not run cord under carpeting. Do not
cover cord with throw rugs, runners, or the
like. Arrange cord away from trac area and
where it will not be tripped over. Do not route
cord under furniture or appliances.
- To prevent a possible re, do not block air in-
takes or exhaust in any manner. Do not use on
soft surfaces,like a bed, where openings may
become blocked.
- A heater has hot or arcing or sparking parts
inside. Do not use it in areas where gasoline,
paint, or ammable liquids are used or stored.
- It is normal for the heater’s plug and cord to
feel warm to the touch. A plug or cord which
becomes hot tothe touch or becomes distort-
ed in shape may be a result of a worn electri-
cal outlet. Worn outlets or receptacles should
be replaced prior to further use of the heater.
Plugging heater into a worn outlet / recep-
tacle/ may result in overheating of the power
cord or re.
- If the supply cord is damage, it must be re-
placed by the manufacturer, its service agent
or similarly qualied person in order to avoid
a hazard.
- WARNING: Do not cover the appliance while
it is functioning in order to avoid overheating
which may cause risk of re.
Please note:
This symbol indicates recommendations and important
information for the user.
- If your appliance is equipped with a poly-
thene tape used as carry handle, remove it
before connecting appliance to the outlet.
- Do not use outdoors.
- Always use the appliance stand alone on the
oor and in an upright position.
- To disconnect heater, turn controls to o, then
remove plug from outlet.
- Connect to properly polarized outlets only.
- This heater is not intended for use with an
extension cord or outlet strip. Plug the cord
directly into an appropriate wall receptable.
- Check that neither the appliance nor the
power cable have been damaged in any way
during transportation.
- Do not use the appliance in rooms with a oor
area of less than 43 square feet (4mq).
- Make sure that no pieces of polystyrene or
other packaging material have been left on
the appliance. It may be necessary to pass
over the appliance with a vacuum cleaner.
- When switching on the appliance for the rst
time, allow it to run at full power for at least
two hours to get rid of the unpleasant smell.
Make sure that the room in which the appli-
ance is located is well ventilated during this
operation. It is normal for the appliance to
emit small cracking sounds when you turn it
on.
SAVE THESE
INSTRUCTIONS
THIS PRODUCT IS FOR HOUSEHOLD USE
ONLY
Loading ...
Loading ...
Loading ...