Loading ...
Loading ...
Loading ...
Light and Adjust Surface Burner Pilots (on standing pilot models)
Be sure surface burner control knobs are in
the OFF position.
Lift the cooktop up and prop it open with
the prop rod provided (see the Care and
cleaning of the range section).
Locate the 2 pilot ports and light each of
them with a match.
If the pilots need adjusting, use a small
flat-bladed screwdriver to turn the adjusting
screw (accessed through a hole in the front
right side of the burner box).
Observe lit burners. Compare the flames
to pictures in the Before you call for service
section. If any flame is unsatisfactory, call
for service.
To avoid pilot outage, slowly lower the
cooktop after lighting the pilots.
28
Consumer Support Troubleshooting Tips Installation Instructions Care and Cleaning Operating Instructions Safety Instructions
To Make Electrical Connection (on electric ignition models)
CAUTION—FOR PERSONAL SAFETY: DO NOT
USE AN EXTENSION CORD WITH THIS
APPLIANCE.
■ This appliance must be supplied with the
proper voltage and frequency, and connected
to an individual, properly grounded and
polarized branch circuit, protected by a circuit
breaker or time-delay fuse, as noted on the
rating plate. (Refer to the rating plate under
the cooktop for this information. See the
Lift-Up Cooktop section in this manual for
instructions on how to lift the cooktop.)
■ Wiring must conform to National Electrical
Codes or the prevailing local code for a range
of this kilowatt rating. (Refer to the rating plate
under the cooktop for this information. See
the Lift-Up Cooktop section in this manual for
instructions on how to lift the cooktop.)
■ If the electric supply provided does not meet
the above specifications, call a licensed
electrician.
WARNING!
Electrical Grounding Instructions
This appliance is equipped with a three prong
grounding plug for your protection against shock
hazard and should be plugged directly into a
properly grounded receptacle. Do not cut or
remove the grounding prong from this plug.
INSURE PROPER GROUND EXISTS BEFORE USE.
Pilot
adjustment
Top pilots adjustment screw controls the
rate of gas to the top burner pilots.
Pilot port
Installation of the range.
Read these instructions completely and carefully.
Loading ...
Loading ...
Loading ...