Loading ...
Loading ...
Loading ...
X
Press retaining clips : at the same time in
the direction of the arrows.
X
Carefully remove the bulb holder together
with the connected plug and the bulbs.
Bulb holder
;
Brake lamp
=
Brake lamp
?
Rear fog lamp
A
Backup lamp
B
Turn signals
X
Brake lamp and backup lamp: remove the
corresponding bulb from the bulb holder.
X
Insert the new bulb into the bulb holder.
X
Rear fog lamp and turn signal: press the
bulb gently into the bulb holder, turn it coun-
ter-clockwise and remove it from the bulb
holder.
X
Insert the new bulb into the bulb holder and
turn it clockwise.
X
Reinsert the bulb holder and engage on
retaining clips :.
X
Close the side trim panel (Y page 107).
Windshield wipers
Switching the windshield wipers
on/off
!
Do not operate the windshield wipers when
the windshield is dry, as this could damage
the wiper blades. Moreover, dust that has col-
lected on the windshield can scratch the glass
if wiping takes place when the windshield is
dry.
If it is necessary to switch on the windshield
wipers in dry weather conditions, always use
washer fluid when operating the windshield
wipers.
!
If the windshield wipers leave smears on the
windshield after the vehicle has been washed
in an automatic car wash, wax or other resi-
dues may be the reason for this. Clean the
windshield using washer fluid after washing
the vehicle in an automatic car wash.
Combination switch
1
$ Windshield wiper off
2
Ä Intermittent wipe, low (rain sensor set
to low sensitivity)
3
Å Intermittent wipe, high (rain sensor
set to high sensitivity)
4
° Continuous wipe, slow
5
¯ Continuous wipe, fast
B
í Single wipe/î Wipes the wind-
shield using washer fluid
X
Switch on the ignition.
X
Turn the combination switch to the corre-
sponding position.
!
Vehicles with a rain sensor: if the windshield
becomes dirty in dry weather conditions, the
windshield wipers may be activated inadver-
tently. This could then damage the windshield
wiper blades or scratch the windshield.
For this reason, you should always switch off
the windshield wipers in dry weather.
Vehicles with a rain sensor: in the Ä or Å
position, the appropriate wiping frequency is
automatically set according to the intensity of
the rain. In the Å position, the rain sensor is
more sensitive than in the Ä position, caus-
ing the windshield wiper to wipe more fre-
quently.
If the wiper blades are worn, the windshield will
no longer be wiped properly. This could prevent
you from observing the traffic conditions.
108
Windshield wipers
Lights and windshield wipers
Loading ...
Loading ...
Loading ...