Loading ...
Loading ...
Loading ...
19
Dishwasher Feedback Section
Canceling a Cycle
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop before completely opening the door.
2. Press and hold CANCEL/DRAIN until the Cancel/Drain light turns on.
3. Close the door. The dishwasher starts a drain cycle if water remains in bottom of dishwasher. Let the dishwasher drain
completely. The Cancel/Drain light turns off after 2 minutes.
Changing a Cycle After Dishwasher Is Started
You can interrupt a cycle and restart your dishwasher from the beginning using the following procedure.
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely.
2. Check whether the detergent dispenser cover is still closed. If it is open, you will need to refill the detergent dispenser
before restarting your new cycle.
3. Press and hold CANCEL/DRAIN twice to reset the control.
4. Select new cycles and options.
5. Press START/RESUME.
Adding a Dish After Dishwasher Is Started
You may add a dish during the first few minutes of the cycle.
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop, and then open the door completely.
2. Add the dish or other items to the load.
3. Press START/RESUME.
4. Close the door (the door must be closed within 3 seconds of pressing Start/Resume or the cycle will not resume). After a cycle is
started (even if Delay Hours has been selected), if the door is opened longer than 3 seconds, the LEDs will flash and an audible
tone will sound to signal that you must press Start/Resume again to resume the cycle.
Cycle Indicators and Time Display
The indicators glow when the dishwasher is washing, drying, complete, and/or sanitized. They also glow
when the control is locked and/or the delay option is selected.
The Status Display is used to follow the progress of the dishwasher cycle and to show other information.
Estimated cycle time is displayed in hours and minutes as you make cycle and option selections. After you
start the dishwasher, the display counts down the time.
When you select the Delay option, the time display will give the number of hours followed by an “H.”
Selecting Cycles and Options
1. To repeat the same cycle/options used on previous cycle, press START/RESUME once to show which selections you used.
To change cycle, select desired cycle.
2. Select the desired options, then press START/RESUME to start the cycle. Not all options are available for every cycle. If an
invalid option is selected for a given cycle, the lights will flash.
Turning the Sound On and Off
Press and hold HIGH TEMP WASH for 3 seconds to toggle sound on and off. The sound will not deactivate for cycle interruption
or service required messages. A screen on the Text LCD will confirm when the sound has been turned off or on.
Loading ...
Loading ...
Loading ...