You can find answers or submit your question.
In ManualsFile, you can ask and answer questions about your issues. We - volunteers - or other people who own the product will help you.
You should also read the documentation for your own answers. Download documentation for this product here.
does this model have a fuse
when i use the reheat button is stays on for a short time then it says steam sensor needs service
Try to reset the electronics by unplugging or by turning off the power at the circuit breaker for 30 seconds or so. If the message continues, please contact GE Appliance Service for assistance.
The Lock Control setting will not unlock. I press and hold the Set Clock button but the display says locked and the red lock symbol stays on
To lock or unlock the controls, press and hold Set Clock for about three seconds. When the control panel is locked, LOCKED will appear in the display.
microwave powers on, but starts running automatically. without pushing any controls.
How do i replace the surface light
You can find instructions on replacing the surface light on page 18 of the Owner’s Manual, found here: https://manualsfile.com/download/tsgszj1u4.html
How to clean the sensor
does this model only have 2 filters to clean or replace
12345 buttons work but 67890 do not. What would the problem be?
How to turn off the vent fan. When I push the vent fan button it goes to medium or boost but won't turn off. Cancel/off button doesn't turn it off.
How do I unlock controls
To lock or unlock the controls, press and hold Set Clock for about three seconds. When the control panel is locked, LOCKED will appear in the display.
Reset filter light stays on
Reset filter light won’t turn off
In order to turn off this light, press and hold the "Reset Filter" button for three seconds. If this does not correct the situation, disconnect power to the microwave for two to three minutes. This will reset the electronic components and should allow you to turn the filter light off. Should the issue persist, please contact GE service.
How do I reset the filter?
Reset Filter light remains on. Notification under Reset Filter button states "hold for 3 seconds." No response or change when this is done. How do I reset filter?
How do U reset the filter?
The Reset Filter light will illuminate after approximately 6 months of use to alert the user to replace the charcoal filter (if used) and clean/replace the grease filters. Reset this by pushing and holding the "Reset Filter" button for 3 seconds.
Can this model be used, sitting on a counter? Or on blocks sitting on a counter?
How do you replace interior light. And where is it located
Follow the steps below to replace the cooktop light: 1. Disconnect the power at the main fuse or circuit breaker panel, or pull the plug. 2. Remove the screw from the side of the light compartment cover and lower the cover until it stops. 3. Be sure the bulb is cool before removing. Break the adhesive seal by gently unscrewing the bulb. 4. Screw in the new bulb, then raise the light cover and replace the screw. Connect electrical power to the oven.
How do I reset filter
The Reset Filter light will illuminate after approximately 6 months of use to alert the user to replace the charcoal filter (if used) and clean/replace the grease filters. Reset this by pushing and holding the "Reset Filter" button for 3 seconds.
How do I reset filter
does control panel have back light
This model does not feature a backlit.
If you have any questions about this product, please ask here.