TaoTronics TT-IC002 Questions & Answers
You can find answers or submit your question.
In ManualsFile, you can ask and answer questions about your issues. We - volunteers - or other people who own the product will help you.
You should also read the documentation for your own answers. Download documentation for this product here.
I cleaned my machine and now when I start it, it starts to fill then stops and the ice full light starts blinking. Any ideas now how to fix this?
Try the troubleshooting steps below:
- Please make sure that there is no barrier or ice on the line of the sensor. Open the lid and close it again.
- Run the clean cycle 1-2 times to see if it helps.
- Please make sure that the back of the ice maker is not close to the wall. Please leave 6 inches of space around.
- Check to see if there is anything clogging the filter. Please take out the filter, and rinse it off with water.
- Please drain the water from the tank and the water from the sink through the drain. Restart it to check if it works.
If this issue persists, please contact the TaoTronics Support via [email protected] for assistance.
Hi ice maker starts up and cools and drawer at top moves and water runs from right through small hole then cuts out after 2 minute but it's as is the scoop thing at top jams
In this case, please contact TaoTronics Support Team at [email protected]
Why does it say add water after I cleaned it and then filled with clean water?
Further investigation found that water is not flowing in container to make the ice . water running straight into the reservoir. How do I fix this
1 likeTry: Fill water upto the max level and press Star/Stop “Ice Full” indicators on
How long does it take for the cleaning cycle?
How do you set the clock?
Press Start/Stop to start ice making cycle (6-8 minutes).
Submit your question
If you have any questions about this product, please ask here.
