Loading ...
Loading ...
Loading ...
8
INSTALLING THE STAINLESS STEEL HANDLE
This beverage merchandiser includes a stainless steel handle that is not required to operate the unit. To
install the handle, follow the instructions below:
1. Pull away the door gasket in the area where the
handle is to be installed. The gasket is easily
displaced by hand; no tools are necessary.
2. Using a flathead screwdriver, remove the two (2)
pre-installed decorative plugs from the back of the
door. Save the decorative plugs for future use.
3. Insert the two (2) Phillips head handle screws with
the lock washers and flat washers through the
gasket side of the door frame until the screws
pass through the door frame. Follow the sequence
shown in the figure.
4. Align the handle with the screws installed in step #
3 above. Tighten the screws using a Phillips head
screwdriver until the handle is both flush and secured tightly against the door frame. (DO NOT over-
tighten as this will cause damage to the handle assembly and door stainless steel surface.)
5. Replace the door gasket to its original position.
OPERATING YOUR APPLIANCE
It is recommended you install the appliance in a place where the ambient temperature is between 72º and
78ºF (23º-26ºC). If the ambient temperature is above or below the recommended temperatures, the
performance of the unit may be affected. For example, placing your unit in extreme cold or hot conditions
may cause interior temperatures to fluctuate. The range of 34º-43ºF (1º-6ºC) may not be reached.
CONTROL PANEL
Temp.
c
F
ON/OFF Power
To turn the appliance ON or OFF, touch the symbol and hold for 5 seconds.
Setting the Temperature Control
You can choose between Fahrenheit and Celsius for the temperature display by touching and
holding the button for 5 seconds. A Fahrenheit or Celsius degree indicator will appear next to
the temperature display window.
You can set the temperature by touching the UP and DOWN symbols. When you push the two
buttons for the first time, the LED readout will show the original temperature set previously. (The
temperature preset at the factory is 38°F (3°C).
Handle
Door Frame
Gasket
Screw
Lock Washer
Flat Washer
Loading ...
Loading ...
Loading ...