Loading ...
Loading ...
Loading ...
Installation
10
ENGLISH
•
Automatic ice maker operation needs water pressure of 147~834 kPa (1.5~8.5 kgf/cm
2
)
(The pressure is correct when an instant paper cup (180 cc) is in 3 sec.).
•
If water pressure does not reach the rating 147 kPa (1.5 kgf/cm
2
) or below, it is
necessary to purchase a separate pressure pump for normal automatic icing and cool
water feed.
•
Keep the total length of the feed water pipe tube within 6.5 m and be careful that the
tube does not bend. If the tube is 6.5 m or longer it may cause water feed problems
owing to the drain water pressure.
•
Install the feed water pipe tube at a place free from heat.
•
Connect to drinking water supply only.
Door Height adjustment
-
Method 1 is recommended.
- Use
1
spanner for freezer.
Method 1 (recommended)
Open the door and adjust the level by using a nut of height
adjusting screw on the lower side of a door with a spanner.
1. Using large side of spanner, rotate release-preventive nuts (
) clockwise to
release rotate release-preventive nuts' tightness.
2. Rotate the Adjust-hinge pin either (
) clockwise or ( ) counter-clockwise
using a narrow side of a spanner to adjust the level difference between the
refrigerator door and freezer door.
3. After adjusting door height, please firmly tighten the Release-prevention nuts
(
) counter-clockwise to the end.
The refrigerator doors will close smoothly by adjusting the front side using the height
adjustment screw. If the doors do not close correctly, performance may be affected.
After levelling
the door height
Next
1. Wipe off all dust accumulated during shipping and clean your appliance thoroughly.
2. Install accessories such as the ice cube box, cover evaporating tray, etc., in their
proper places. They are packed together to prevent possible damage during shipping.
3. Connect the power supply cord (or plug) to the outlet. Don’t double up with other
appliances on the same outlet.
•
Do not adjust the height level too much. The hinge pin can be fallen out.
(Range of height adjustment : Max. 3mm)
Height difference
CAUTION
Spanner
Release
Preventing Nut
Adjust Hinge Pin
Lower Door
Down
Raising
Door Up
Raising
Door Up
Release
Preventing Nut
Adjust Hinge Pin
Lower Door
Down
Raising
Door Up
Nut Releasing Nut Tightening
Model: GSL54*****, GSP54*****, GWL31****, GWP31****
Method 2 (only for Plumbing type)
Loading ...
Loading ...
Loading ...