Loading ...
Loading ...
Loading ...
5
OPERATING INSTRUCTIONS
Option Selections
AIR DRY
The AIR DRY option uses reduced temperature
in the nal rinse. While saving energy and time,
you may have items in your dish load that will
not be completely dry at the end of the cycle.
Deselecting AIR DRY option in combination with
rinse aid will enhance drying performance. AIR
DRY option is not available on all cycles.
SANITIZE
To sanitize your dishes and glassware, select
SANITIZE option, by pressing SANITIZE
pad. When selected, the light will come on
and remain on after the cycle has completed.
The water temperature in the nal rinse will be
raised to 155°F (68°C) and will maintain that
temperature for 9 minutes. This option is available
in HEAVY and NORMAL wash cycles. Only these
sanitization cycles have been designed to meet
NSF requirements.
The cycle time will be extended until the proper
water temperature is reached. Washing action will
continue during the water heating delay. For best
results, the incoming water temperature should be
at least 120°F (49°C).
The sanitize criteria may not be satised if there
is an interruption of the cycle, power failure or if
the incoming water temperature is below 120°F
(49°C).
Sanitize pad ashes at the end of the cycle if the
NSF requirements for sanitization are not reached.
To turn o the SANITIZE option, press the
SANITIZE pad. The SANITIZE light will turn o.
My Favorite Cycle
The MY FAVORITE CYCLE option allows you
to program your preferred cycle and options into
one button. Once Programmed, simply press the
MY FAVORITE CYCLE button followed by the
START/CANCEL pad to select the programmed
cycle and options.
To Program the MY FAVORITE CYCLE button:
1. Select your preferred cycle and options
2. Hold the MY FAVORITE CYCLE button for 3
seconds.
The LED over the MY FAVORITE CYCLE turns
on indicating the MY FAVORITE CYCLE option
has been programmed. To change the MY
FAVORITE CYCLE option simply repeat steps
one and two above.
HIGH
HIGH option is selected, by pressing the
HIGH pad. The dishwasher heats water in the
main wash to approximately 140°F (60°C) and
increases the temperature higher in the nal rinse
to help with the drying stage.
This helps dishwasher detergent remove food
grease and soil from dishes more eectively and
aids in drying performance by adding additional
rinse aid and increasing the water temperature.
To Start a Cycle
When the cycle and options have been selected,
the LEDs over the cycle and options selected will
illuminate. The status window will display the
cycle time and then displays “Press START”.
To start the cycle, press START/CANCEL pad
and close the door immediately.
The status window displays “Close” after the
START/CANCEL pad is pressed.
A tone will sound indicating the cycle has
successfully started after the door is closed.
SPRAY
Press SPRAY pad to select this option. This varies
the pressure optimally for the cycle’s intended
normal use.
SCOUR
Press SCOUR pad to select this option. This
provides a very high “scour” pressure. Due
to wash cycle optimization, this option is not
selectable in all wash cycles.
SPRAY and SCOUR can not both be selected to
run together.
Loading ...
Loading ...
Loading ...