Loading ...
Loading ...
Loading ...
22
COMPLETE INSTALLATION
CHECKLIST
❑
Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
❑
Check that you have all of your tools.
❑
Dispose of/recycle all packaging materials.
❑
Check dryer’s nal location. Be sure vent is not crushed
or kinked.
❑
Check that dryer is level. See “Level Dryer.”
❑
Remove lm on console and any tape remaining on dryer.
❑
Wipe dryer drum interior thoroughly with a damp cloth
to remove any dust.
❑
Read “Dryer Use” in your “Use and Care Guide.”
❑
Set the dryer on a full heat cycle (not an air cycle)
for 20 minutes and start the dryer.
❑
Be sure the water faucets are on.
❑
Check for leaks around “Y” connector, faucet, and hoses.
❑
If you live in a hard water area, use of a water softener is
recommended to control the buildup of scale through the
water system in the dryer. Over time, the buildup of lime
scale may clog different parts of the water system, which will
reduce product performance. Excessive scale buildup may
lead to the need for certain part replacement or repair.
If the dryer will not start, check the following:
■ Dryer is plugged into a grounded 3-prong outlet.
■ Electrical supply is connected.
■ Household fuse is intact and tight, or circuit breaker
has not tripped.
■ Dryer door is closed.
❑
When the dryer has been running for 5 minutes, open the
dryer door and feel for heat. If you feel heat, cancel cycle
and close the door.
If you do not feel heat, turn the dryer off and check to see
whether gas supply line shut-off valve is open.
■ If the gas supply line shut-off valve is closed, open it,
then repeat the 5-minute test as outlined above.
■ If the gas supply line shut-off valve is open, contact a
quali ed technician.
NOTE: You may notice an odor when the dryer is rst heated.
This odor is common when the heating element is rst used.
The odor will go away.
REVERSE DOOR SWING
(OPTIONAL)
NOTE: Magnetized screwdriver is helpful.
Place towel on top of dryer to avoid damaging the surface.
1. Place towel on dryer
2. Remove bottom screws
Open dryer door. Remove bottom screws from dryer cabinet
side of hinges. Loosen (do not remove) top screws from dryer
cabinet side of hinges.
Lift door until top screws in dryer cabinet are in large part of
hinge slot. Pull door forward off screws. Set door (handle side
up) on top of dryer. Remove top screws from dryer cabinet.
3. Lift door off top screws
Loading ...
Loading ...
Loading ...