Loading ...
Loading ...
Loading ...
76
Get the most out of it
Maximum speed is recommended for fast initial cleaning or for heavily polluted air. After a few minutes,
the speed can be reduced. Minimum speed is generally recommended for nighttime use.
For best results, run Sense+ 24/7. This ensures that clean, filtered air constantly circulates throughout
the room. Sense+ uses as little as 7 W, less than a low-energy light bulb.
Start it
Plug Sense+ into a grounded electrical outlet with the supplied power cord. To turn it on for the first
time, sweep your hand over the top display. A blue LED on the front side indicates that the unit is
working.
Place it
Sense+ should be placed in a location that allows air to circulate freely in, out and around the unit.
Minimum distance from another object is 10 cm.
Don’t place the unit:
Directly on or against soft furnishings, such as bedding or curtains.
Near sources of heat, such as radiators, fireplaces or ovens.
Near wet areas, such as bathrooms or laundry rooms, where it may come into contact with water.
Outdoors.
Warning: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
FCC ID: 2AEX3-Sense+
IC ID: 20267-Sense+
However, there is no guarantee that interference will not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
This Class B digital apparatus complies with Canadian ICES-003.
FCC RF Radiation Exposure Statement Caution: This Transmitter must be installed to provide a
separation distance of at least 20 cm from all persons.
Loading ...
Loading ...
Loading ...