Loading ...
Loading ...
Loading ...
en Faults and what to do about them
32
3 Faults and what to do about them
Faults and what to do about them
Faults Cause/remedy
ð in the display panel
and drying has been
interrupted.
■ Empty the condensate container; ~ Page 27 and the dryer; ~ Page 14.
■ If the optional condensation drain is installed, the drain hose may be
blocked. Check the hose for deposits and flush the hose out.
é in the display panel. Clean the fluff filter and/or the heat exchanger, then select the Start button
~ Page 26; ~ Page 30.
Dryer does not start. ■ Mains plug plugged in or fuse checked?
■ Programme selected? Select a programme.
■ Dryer door open? Close the door.
■ Is the childproof lock activated? Deactivate the child-proof lock.
■ "Ready in" time selected? Programme starts after a delay.
Display panel goes off
and Start button flashes.
Not a fault. Energy-saving mode is active ~ Page 12.
Creasing. ■ Creasing occurs when you have exceeded the maximum load or selected
the wrong programme for the type of fabric. All the required information
can be found in the programme table.
■ Remove clothes immediately after drying; creasing may occur if they are
left in the drum.
Water is leaking out. Not a fault; the dryer may be positioned on an incline. Level the dryer.
Change in the
programme duration
displayed during drying.
Not a fault. The moisture sensors detect the remaining moisture in the load and
adjust the programme length (except timed programmes).
Laundry is not dried
correctly or is still too
damp.
■ After the end of the programme, warm laundry feels damper than it actually
is. Spread the laundry out and allow the heat to disperse.
■ Finely adjust the dryness level – this extends the drying time but does not
increase the temperature. Your laundry becomes drier ~ Page 24.
■ Select a programme with a longer drying time or increase the drying level.
This does not increase the temperature.
■ Select a time programme for subsequent drying of laundry that is still damp
~ Page 22.
■ If you have exceeded the maximum load for the programme, the laundry
may not be dried properly.
■ Clean the moisture sensor in the drum. The sensor may become covered by
a fine layer of limescale or residues of detergents and care products which
then impair its function. Your laundry is not being dried correctly
~ Page 31.
■ Drying has been interrupted as a result of a power cut, because
the condensate container is full or because the maximum drying time has
been exceeded.
Note: See also the laundry tips ~ Page 21.
* Depending on the model
Loading ...
Loading ...
Loading ...