Loading ...
Loading ...
Loading ...
Operating the Dishwasher en-us
31
Auto power off
This setting determines the length of
time the control panel stays
illuminated after the cycle is
complete. To save energy the
recommended setting is ˜:‹‚.
This setting can be adjusted from
˜:‹‹ to ˜:‹ƒ.
To change the setting:
1.
Press the On/Off button (.
2.
Hold down the function key #
and press the Start button P
until the display 8 indicates
š:‹x (x can be any number).
3.
Release both buttons.
4.
Press the function key # until
the display 8 indicates ˜:‹x.
5.
Press the function key 3 until
the display corresponds with your
requirements.
6.
Press the Start button P.
Switching off the appliance
Short time after the end of the wash
cycle:
1.
Press On/Off button (.
2.
Turn off water supply.
3.
Remove the utensils when they
have cooled down.
9 WARNING
RISK OF INJURY!
To avoid risk of injury, always
use caution when opening the
door during or following a wash
cycle as hot water or steam
may escape. Do not fully open
the door until water noises have
stopped and steam has
subsided.
Interrupting the wash cycle
9 CAUTION
Expansion (overpressure) may
cause the appliance door to
open and/or water to escape! If
the door was opened on an
appliance which has a hot water
connection or is heated, always
leave the door ajar for several
minutes and then close.
1.
Press On/Off button (.
The LED’s go out. The wash cycle
is saved.
2.
To continue the wash cycle, close
the door and press On/Off button
( again.
Note: Your dishwasher is protected
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Close the appliance door
and press the Start button P again.
˜:‹‹ dishwasher does not turn off
automatically
˜:‹‚ dishwasher turns off
automatically after 1 minute
˜:‹ƒ dishwasher turns off
automatically after
120 minutes (2 hours)
Loading ...
Loading ...
Loading ...