Loading ...
Loading ...
Loading ...
32
ELECTRONIC CONTROL SETUP INSTRUCTIONS
Dryer Diagnostic Mode
This mode is entered by depressing COLORS/DELICATES for one
second while in either of the set-up codes 6 xx or 7 xx or with
a diagnosc code present. Diagnosc codes are cleared on
entry and all display segments should ash. If a diagnosc code
persists, it must be corrected before the diagnosc cycle can
be entered.
With all segments ashing, the diagnosc cycle is started by
depressing the PERM PRESS buon. The cycle consists of
7 minutes of heat and 1 minute of cooldown.
The COTTON/WHITES buon will increment the diagnosc
cycle minutes up to 99, then roll over to 2 minutes. The
COLORS/DELICATES buon will cancel this cycle and exit
the diagnosc mode.
Dryer Help Mode
Dryer help mode is entered by pressing the COTTON/WHITES
buon while in special pricing opon 2.XX. In help mode, the
soware revision is displayed. The help mode is advanced by
pressing the PERM PRESS buon. See Help Mode Submenu
below for the order in which items are displayed. Press the
COTTON/WHITES buon at any me to exit help mode.
Help Codes
Help Code Description
71 Generaon 2 debit card
cycle polling message out of
sequence.
74 Generaon 2 debit card
remaining balance message
out of sequence.
75 Generaon 2 debit card new
card balance message out of
sequence.
88 Invalid messaging state
found in data acquision
communicaons comm_
suprv ( ) roune.
Step Display
Indication
Explanation
1 1h.XX Help Code 1, where XX is the help
code number. *
2 2h.XX Help Code 2, where XX is the help
code number. *
3 3h.XX Help Code 3, where XX is the help
code number. *
4 1.X## Error history code 1, where X is
the F or d code, and ## is the code
number. **
5 2.X## Error history code 2, where X is
the F or d code, and ## is the code
number. **
6 3.X## Error history code 3, where X is
the F or d code, and ## is the code
number. **
7 4.X## Error history code 4, where X is
the F or d code, and ## is the code
number. **
8 SC.XX CCU soware revision, where XX is
the soware revision number.
9 SU.XX UI soware revision, where XX is
the soware number.
10 EU.XX UI EEPROM revision, where XX is
the EEPROM number.
* To erase the 3 help codes, press COLORS/DELICATES buon.
** The Errors displayed in this secon are the history errors
that have occurred in the dryer (not necessarily an error
that is in progress). The current error is displayed in the
MANUAL KEY FUNCTION IN DIAGNOSTIC SUB-MODE.
In help mode, other display symbols and elements are mapped
to reect the state of various inputs and outputs as follows:
All Dryers
*.. . . . . . . . . . . . . . . . .low voltage present (below about 90 VAC)
°(circle above digit) . . . . . . . . . . . . . . . . . . . . . . . . . . . door closed
OR. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . motor sensed running
AIR. . . . . . . . . . . . . . . . . . . . . . . . . . . . . heater/gas valve relay on
FLUFF. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . motor relay on
Loading ...
Loading ...
Loading ...