Loading ...
Loading ...
Loading ...
19
NOTE: You may press ICE/WATER “Back” at any time to exit
calibration mode. The Calibrate Measured Fill icon will
disappear.
3. Press and release the ice/water dispenser paddle, as needed,
to dispense water to the 1 cup fill line.
NOTE: If overfilling or spilling occurs, discard the water and
press ICE/WATER “Back” to restart the calibration process.
4. When 1 cup of water has been correctly dispensed into the
measuring cup, press the MEASURED FILL button under the
word “Confirm” to confirm the calibration.
5. When Measured Fill calibration has been confirmed the icons
will disappear and the display will return to the home screen.
Dispensing
Press ICE/WATER to toggle through the following choices in a
continuous loop:
■ Water (default) - Dispenses water
■ Cubed - Dispenses cubed ice.
■ Crushed - Dispenses crushed ice
NOTES:
■ The word “ICE” appears on the display screen when either
crushed or cubed ice is selected.
■ For crushed ice, cubes are crushed before being
dispensed. This may cause a slight delay when dispensing
crushed ice. Noise from the ice crusher is normal, and
pieces of ice may vary in size.
■ When changing from crushed to cubed, a few ounces of
crushed ice will be dispensed along with the first cubes.
The Water Dispenser
IMPORTANT:
■ Dispense at least 1 qt (1 L) of water every week to maintain a
fresh supply.
■ If the flow of water from the dispenser decreases, it could be
caused by low water pressure.
■ With the water filter removed, dispense 1 cup (237 mL) of
water. If 1 cup (237 mL) of water is dispensed in 8 seconds
or less, the water pressure to the refrigerator meets the
minimum requirement.
■ If it takes longer than 8 seconds to dispense 1 cup
(237 mL) of water, the water pressure to the refrigerator is
lower than recommended. See “Water Supply
Requirements” and “Problem Solver” or “Troubleshooting”
for suggestions.
To Dispense Water (Standard):
1. Select water.
2. Press a sturdy glass against the dispenser paddle.
NOTE: While dispensing water and for 3 seconds after
dispensing has stopped, the digital display will show how
much water has been dispensed.
3. Remove the glass to stop dispensing.
To Dispense Water (Measured Fill):
Measured Fill allows you to dispense a specified amount of water
with the touch of a few controls.
NOTE: The amount of water you select will be dispensed. Be sure
that the container is empty and can hold the entire volume. If ice is
in the container, you may need to adjust your selection.
A. 1 cup of water
A
Water Crushed Cubed
Loading ...
Loading ...
Loading ...